Where is the ignition switch on a 2004 f150?
Where is the ignition switch on a 2004 f150?
The ignition switch on your Ford truck is mounted on the right side of the steering column. The ignition switch has an “accessory” position that can be activated when the key is turned counterclockwise from the “off” position.
How do you replace a steering column in a Ford F150?
Take off the steering column covers by removing the fastener from the lower cover, separating the two halves, removing the lower cover and unfastening and removing the upper cover. Unplug the two electrical connectors to the steering column harness and detach the harness from the bracket.
How do you replace the ignition switch on a Ford F-150?
Straighten out a small paper clip and insert one end of it approximately 2 inches into the small hole located in the steering column directly below the ignition switch. Pull the ignition switch from the steering column and remove the key. Insert the key into the new ignition switch. Insert the ignition switch into position in the steering column.
When to replace ignition cylinder actuator rod F150?
Keywords: ford f150 f-150 key ignition accessory start run on in repair replace fix broken broke actuator rod plastic assembly steer steering column starter This procedure is from a 2001 F-150 with power door lock problems.
How do you remove a steering column cover?
Detach the lower steering column panel by removing its mounting fasteners with a wrench. Take off the steering column covers by removing the fastener from the lower cover, separating the two halves, removing the lower cover and unfastening and removing the upper cover.
Take off the steering column covers by removing the fastener from the lower cover, separating the two halves, removing the lower cover and unfastening and removing the upper cover. Unplug the two electrical connectors to the steering column harness and detach the harness from the bracket.
Keywords: ford f150 f-150 key ignition accessory start run on in repair replace fix broken broke actuator rod plastic assembly steer steering column starter This procedure is from a 2001 F-150 with power door lock problems.
How to replace a steering column ignition tumbler?
Step 9: Use a dental tool to remove the locking pin from the ignition tumbler. On some models you may have to punch out the pin to the tumbler. Step 10: Pull out the ignition tumbler from the steering column. Reach in and pull out the rod from the steering column. Step 11: Remove the mounting screws under the column that hold on the actuator.
What to do if your steering column does not start?
If the engine does not start up with a tilt column, try to move the column up and down to see if the engine starts up. While the key is in the ignition tumbler and the key is in the on position, try to pull out the key.
