Where is the best place to install a door jamb switch?
Where is the best place to install a door jamb switch?
Here is how it is done. It is best for the switch to be installed above the door hinge. This means that the switch will be installed on the door’s hinge side. This location is perfect because the door presses the switch as it closes. Once it opens again, it releases the switch and turns on the light.
How do you connect a closet light to a door jamb switch?
Always exercise caution when working with electrical wiring. Connect the closet light to the switch by running a wire through the drilled hole. This wire will run from the knockout closure to the junction box. Make sure to make the proper connections. Refer to the manufacturer’s manual for specific instructions on wiring.
Do you need a jack stud for a jamb switch?
When the door is open the spring-loaded button completes the circuit and turns the light on. If you are not installing a jamb switch simply skip to the next step. With a jamb switch comes a matching electrical box. The jack stud will need to be notched out to accept this box.
How do you attach a door jamb to a frame?
Be sure to put a nail through each shim to hold them in place. Weather strips are a good way of hiding screw marks. Screws make exterior doors stronger and more adjustable. Drill a hole in the jamb before adding the screws, then attach the weather strips over them. Secure the other sides of the jamb to the frame. Move onto the top side.
Can a door jamb switch be put on a closet door?
The door jamb switch can be a very useful device that can be installed on the hinge side of a closet door. With this type of switch, it will not be necessary to switch the closet light on or off manually. Door jamb switches offer convenience because most closet lights are hard to reach or hard to find in the dark.
When the door is open the spring-loaded button completes the circuit and turns the light on. If you are not installing a jamb switch simply skip to the next step. With a jamb switch comes a matching electrical box. The jack stud will need to be notched out to accept this box.
What’s the best way to install a door jamb?
Place a 6ft level on the hinge side of the frame and check for any gaps of high spots. Shim if necessary to get the jamb side perfectly straight. Also assure the frame is square with the wall. You can do this using a square. The hinge side can now be secured with 2-1/2″ trim screws.
How do you install a light switch in a closet?
Secure the plate cover to the junction box of the switch and screw all connections in place. Make certain that the screws will not interfere with the closing of the closet door. Turn on the power and check if the switch works. If the light turns on when the door is opened and turns off when the door is closed, the installation is successful.
