Where does the starter go on a Dodge Stratus se?

Where does the starter go on a Dodge Stratus se?

The 2004 Dodge Stratus SE with the 2.4-liter engine has a top-mounted starter, meaning that you can remove the starter through the top of the engine compartment without having to raise the vehicle. If you are confident working with your hands and have a basic set of tools, you can replace your starter in your driveway.

How do you remove the ground wire from a starter?

Using a ratchet and socket, remove the starter mounting bolts and the ground wire from the starter mounting flange. Unplug the solenoid electrical connector. Using a ratchet and socket, remove the starter terminal nut and disconnect the solenoid and B+ wires from the starter.

How do you remove a starter from a car?

Using a ratchet and socket, remove the starter terminal nut and disconnect the solenoid and B+ wires from the starter. Remove the starter from the engine compartment. Install the wires and nut on the terminal and torque the nut to 90 inch-pounds, using a torque wrench and socket.

How do I torque a solenoid starter to 90 inches?

Install the wires and nut on the terminal and torque the nut to 90 inch-pounds, using a torque wrench and socket. Connect the solenoid wire to the solenoid terminal, and position the starter in its place. Install the retainer bolts and the ground wire. Tighten the bolts to 40 foot-pounds.

Where do you change the starter in a car?

If you are confident working with your hands and have a basic set of tools, you can replace your starter in your driveway. Open the hood and locate the battery at the rear driver-side corner of the engine compartment.

The 2004 Dodge Stratus SE with the 2.4-liter engine has a top-mounted starter, meaning that you can remove the starter through the top of the engine compartment without having to raise the vehicle. If you are confident working with your hands and have a basic set of tools, you can replace your starter in your driveway.

If you are confident working with your hands and have a basic set of tools, you can replace your starter in your driveway. Open the hood and locate the battery at the rear driver-side corner of the engine compartment.

Using a ratchet and socket, remove the starter mounting bolts and the ground wire from the starter mounting flange. Unplug the solenoid electrical connector. Using a ratchet and socket, remove the starter terminal nut and disconnect the solenoid and B+ wires from the starter.

Using a ratchet and socket, remove the starter terminal nut and disconnect the solenoid and B+ wires from the starter. Remove the starter from the engine compartment. Install the wires and nut on the terminal and torque the nut to 90 inch-pounds, using a torque wrench and socket.

Install the wires and nut on the terminal and torque the nut to 90 inch-pounds, using a torque wrench and socket. Connect the solenoid wire to the solenoid terminal, and position the starter in its place. Install the retainer bolts and the ground wire. Tighten the bolts to 40 foot-pounds.