Where does the battery cable go on the starter?
Where does the battery cable go on the starter?
If the starter solenoid is separate, however, you’ll have an extra set of connections. In that case, the starter cable connects from the starter to the solenoid, and the battery cable connects from the solenoid to the battery. The negative connectors in either case connect to the chassis as ground wires.
What kind of wire do you need for a starter?
The wire must be a thick cable, as the starter uses amperage, not voltage, to start. The typical positive battery cable is 4 gauge. The typical negative battery cable is 2 gauge.
How does a starter motor hook up to a negative terminal?
Re-installed the starter motor. When hooking up the new battery, I hooked up the positive side. When I touched the negative cable to the negative terminal, there were sparks, and the starter motor engaged and tried to start the engine. The keys were not in the ignition and the ignition was in the locked position.
Where is the Starter Cable on a PmgR starter?
But, since a PMGR starter has its own relay we can move the Starter Cable to the battery side, as shown in the bottom diagram, and run a smaller wire from the output of the relay/solenoid to the small terminal on the starter.
How to change the positive battery cable on the starter?
Attach one end of the new positive battery cable to the solenoid by sliding the cable over the stud on the solenoid and securing the nut over the cable end. Attach the free end of the cable to the battery cable post on the starter by securing the nut over the cable end. Reattach the positive battery cable to the positive battery terminal.
What kind of wire do you need for a Chevy starter?
A Chevy starter requires a lot of amperage, which in turn requires a large 4-gauge wire from the battery to the starter solenoid. The solenoid acts like a switch, opening and closing the high amperage circuit to the starter. The ignition key supplies the power to actuate a relay, which in turn actuates the solenoid. Step 1
How do you wire a Chevy starter relay?
Connect the inline fuse to the battery positive terminal by using the 14-gauge wire and installing a yellow circular post connector on the end of the wire. Crimp it with the crimping tool. Install this terminal under the bolt on the positive terminal. Unroll the wire and run it to the starter relay.
Re-installed the starter motor. When hooking up the new battery, I hooked up the positive side. When I touched the negative cable to the negative terminal, there were sparks, and the starter motor engaged and tried to start the engine. The keys were not in the ignition and the ignition was in the locked position.
