When to replace the PCV valve on a Chevy Silverado?
When to replace the PCV valve on a Chevy Silverado?
Among the complex mechanical components that allow an engine to function, the PCV valve is one of the smaller parts but just as significant. If this valve is clogged in your Silverado, replace it as soon as possible before other problems arise.
What kind of engine does a Chevy Silverado have?
GM 6.0L V8 Vortec L96 Engine Specs Type: 6.0L Gen IV V8 Small Block E85 Flex Fuel: Chevrolet Express (Passenger,Cargo), GMC Chevrolet Silverado HD < 10,000 lbs: 360 hp (268 kW) @ 5400 RPM SAE Certified GMC Sierra HD < 10,000 lbs: 360 hp (268 kW) @ 5400 RPM SAE Certified
What’s the normal oil pressure for a Silverados 6.0?
About 165-170 PSI for compression across all cylinders and the spark plugs burn cleanly with good color. The bottom end of this engine has never been touched and the motor is doing well other than needing a few top end engine sensors replaced – engine coolant temperature, camshaft position sensor, both knock sensors and harness.
How do you remove a PCV valve from a hose?
The PCV hose is the widest of the three hoses in this location (the two thinner hoses are connected to the firewall). Follow this hose to the valve cover and pull out the hose with attached PCV valve. Then remove the PCV valve from the hose.
Among the complex mechanical components that allow an engine to function, the PCV valve is one of the smaller parts but just as significant. If this valve is clogged in your Silverado, replace it as soon as possible before other problems arise.
The PCV hose is the widest of the three hoses in this location (the two thinner hoses are connected to the firewall). Follow this hose to the valve cover and pull out the hose with attached PCV valve. Then remove the PCV valve from the hose.
Where is the PCV valve on a Honda Accord?
Make sure the engine is off and has cooled down before starting the job. Use an 8 mm socket and ratchet to remove the center bolt on top of the engine cover. Then lift the cover off and set it aside. Figure 1. Remove the 8 mm engine cover bolt. The PCV valve is located at the rear of the engine on the side nearest to the brake fluid reservoir.
Where is the PCV valve located on an 8 mm engine?
Use an 8 mm socket and ratchet to remove the center bolt on top of the engine cover. Then lift the cover off and set it aside. Figure 1. Remove the 8 mm engine cover bolt. The PCV valve is located at the rear of the engine on the side nearest to the brake fluid reservoir.
