When does pin 6 start showing zero voltage?
When does pin 6 start showing zero voltage?
Pin 6 should read zero voltage from 2003-2004 for GM and Ford vehicles but would start showing voltage reading on 2005 model, Chrysler would show zero voltage from 2003-2006 but would start showing voltage reading on 2007 model. Finally, Toyota vehicles showed voltage reading starting 2003 -2008 models.
Is there power to pin 16 on OBD2?
It can do strange things. Yes I have power to pin 16 (the power to the scanner) I also have good grounds at pins 4 and 5. Pin 2 (which is the signal from the ECU) has very low voltage. I’m using a good OBD2 reader that works on every vehicle I’ve ever used it on.
Is there low voltage to signal wire pin 2?
There is very low voltage to the “signal wire” pin 2. It should be 5 volts but it is 0.3 volts. This site shows a lot but I don’t know what the diagram means S1 through S9 or whatever. Where are these splice bars located and how in the world do I do the tests they suggest?
How to fix no power no start on most Mercedes-Benz?
HOW TO FIX NO POWER NO START ON MOST MERCEDES-BENZ VECHICLES DIY. – YouTube HOW TO FIX NO POWER NO START ON MOST MERCEDES-BENZ VECHICLES DIY. If playback doesn’t begin shortly, try restarting your device.
It can do strange things. Yes I have power to pin 16 (the power to the scanner) I also have good grounds at pins 4 and 5. Pin 2 (which is the signal from the ECU) has very low voltage. I’m using a good OBD2 reader that works on every vehicle I’ve ever used it on.
There is very low voltage to the “signal wire” pin 2. It should be 5 volts but it is 0.3 volts. This site shows a lot but I don’t know what the diagram means S1 through S9 or whatever. Where are these splice bars located and how in the world do I do the tests they suggest?
Why does my Mini Cooper engine not start?
As soon as the power relay failed the car wouldn’t start. It would turn over but wouldn’t start. As if there was a flat battery. If you scanned the the car it wouldn’t find the engine ECU and log that as a fault. This was because there was no power powering the Engine ECU and hence the software couldn’t talk to the ECU .
