When did the fuel pump quit on my Chevy Silverado?

I recently purchased a 1999 Chevy Silverado and the fuel pump quit within a week. Going the the internet I find it is a very common problem. One man said he went though 3 pumps in 30,000 miles.

How big is the fuel pump hole on a Chevy Silverado?

So after careful measuring I cut a square 7″ wide by 12″ long out of the bed with my 4 1/2″ die grinder. 6″ back from the front of the bed and 14″ in from the side. I riveted strips of sheet metal to the sides of this piece and it sets right back in its original hole with sheet metal screws to hold in in place.

Why is my fuel pump not working when I replace it?

The concern with the fuel gauge is a common issue when replacing the fuel pump. The fuel level sensor is a separate component attached to the fuel pump. This part does not always come with the fuel pump and sometimes is not interchangeable with aftermarket fuel pumps. Chevrolets have a common issue with fuel filters getting clogged.

Can a car pump be submerged in gas?

Always keep enough fuel in the tank for the pump to be submerged in gas. Choose high quality car gasoline. Fuel comes through filter to the Tubine Impeller. So if the fuel contains too much impurities, it can block the filter and damage the Tubine Impeller. So please replace the Filter on a regular basis and always use high quality gasoline.

What is the fuel pump relay on a 1992 Chevy 1500?

The fuel pump relay on a 1992 Chevrolet 1500 is designed to regulate power to the fuel pump depending upon the position of the ignition key. This relay is controlled by the powertrain control module (PCM).

I recently purchased a 1999 Chevy Silverado and the fuel pump quit within a week. Going the the internet I find it is a very common problem. One man said he went though 3 pumps in 30,000 miles.

How to remove a fuel pump from a truck?

Basic instructions on how to tip your bed and remove your fuel pump and sender assembly, replacement of the fuel pump from the sender unit and putting it back into the tank with gasket o-ring and lock ring. I also show video of the bolt hole locations on my short bed frame. Loading…

How do you Drop the fuel tank on a Chevy Silverado?

This article will walk you through the second method of dropping the fuel tank. Open the hood. Pull the fuel pump relay from the fuse box. Start the vehicle and let it run until it shuts down. Figure 1. Pull the fuel pump relay and start the engine in order to relieve gas pressure in the line and the pump.

What are the symptoms of a bad fuel pump?

Here are the most common symptoms of a bad fuel pump in your Chevy Silverado: One of the most common signs that a fuel pump is going bad is a whining sound. The whining sound can indicate that the fuel pump is going out before there are any performance based issues. Keeping an open ear can save you from getting stuck somewhere with a bad fuel pump.

When to replace the fuel pump on a Chevy Silverado?

If your Chevrolet Silverado isn’t performing the way it once did, or if you feel like you’re stepping on the gas pedal and not much is happening, it may be time to replace the fuel pump. This article applies to the Chevrolet Silverado (1999-2006).

How do you replace a fuel pump relay?

Reconnect the power plugs to the top of the fuel pump with the quick connect wiring harnesses. Reconnect the fuel lines and lastly, reconnect the filler neck and tighten down the hose clamp and the vapor hose. Keep the truck in the air while you replace the fuel pump relay and start your truck.

Do you need to replace fuel filter when replacing fuel pump?

The fuel level sensor is a separate component attached to the fuel pump. This part does not always come with the fuel pump and sometimes is not interchangeable with aftermarket fuel pumps. Chevrolets have a common issue with fuel filters getting clogged. You always want to replace the fuel filter when replacing the fuel pump.

Why does my Silverado have a trouble code P0420?

If you get P0420 or P0430 trouble codes with a scanner, it very well may be the catalytic converter causing these symptoms. One of the best indicators of a clogged fuel pump is going to be that the your Silverado is difficult to start. This because there’s not enough fuel pressure to properly atomize the fuel as it enters the combustion chamber.

What happens if you replace the fuel pump?

– Bed has no affect on pump circuit. Also if you had to replace the connector for the new PUMP MODULE, (i hope) make sure color code is correct, some dont match up. Read instructions again! Be sure the four wire connectors are making good contact.