When did I change the fuel pump on my GMC Sierra?

I changed the fuel pump on my 1996 GMC Sierra earlier in the year. I cut through my truck bed right above the fuel pump so I would have easier access to it. For the most part my truck has been fine but I have had problems with the ground wire coming from the fuel pump. At first I thought it was just the old rusty bolt that grounds the fuel pump

How to test a suspect fuel pump relay?

1 The easiest way to test a suspect fuel pump relay is to; swap the suspect relay with a good one. 2 You may find another relay in your car with the same configuration as your fuel pump relay. Just make sure the other relay has the same configuration. 3 Remove the suspect relay and install the good relay and check if your engine fires up. …

Can you test the fuel pump on a GM Truck?

And although GM did not include a Schrader valve to which you could connect a fuel pressure gauge, it can be tested with one to find out if the fuel pump is producing the correct pressure (or not).

Is there no power to the fuel pump?

No power to the fuel pump and the fuel relay is not getti… Q: No power to the fuel pump and the fuel relay is not getting power. My car has 190000 miles.

How to fix ground wire from fuel pump connection?

Same with the power wire from the relay to the fuel pump connector.You can also try sliding the wire between two fingers while slightly bending the wire to feel for a soft spot but this may not work due to the fact that it works sometimes so the bad spot isn’t real big yet. 5 people found this helpful.

How to remove a fuel pump from a truck?

Basic instructions on how to tip your bed and remove your fuel pump and sender assembly, replacement of the fuel pump from the sender unit and putting it back into the tank with gasket o-ring and lock ring. I also show video of the bolt hole locations on my short bed frame. Loading…

Why does my fuel pump wire keep dying?

ground wire coming from the fuel pump. At first I thought it was just the old rusty bolt that grounds the fuel pump wire to the frame so I switched the bolt out. The newer bolt and nut did okay for awhile then my truck started dying on me. I would mess with the wire and bolt eventually it would start. So the other day my truck died on me and I had

Where is the connector on a Chevy fuel pump?

When you get the Delco replacement parts it comes with a new connector on the fuel pump side. The problem is the connector on the vehicle side of the harness. In the online Chevrolet repair manual I use, a Tech Tip states, the connector should be replaced with the fuel pump assembly.

When was the last time my Chevy fuel pump failed?

The technical service bulletin that explains the cause of the repeat failure of the Chevy fuel pump replacement unit covers all years from 1996 to 2003 and includes all of the pickup trucks. Also included is the Tahoe and suburban and their GMC counterparts such as the Sierra and Envoy. Oh and don’t forget the Cadillac Escalade is also included.

What to do if your Chevy fuel pump fails?

Chevrolet fuel pump failures are a common and growing problem. If you have a fuel pump harness connector that looks like the flat one on the right or the square one at the bottom, then consider replacing it when replacing the pump. More details about this are below, but you might want to download your Chevy manual to help.

When did the Chevy fuel pump come out?

It started on Chevrolet truck models from 1996 to 2003 model years, but has expanded to other models as the connector and pump assemblies are not aging well. In fact, I have a financially strapped friend with an 04 Silverado that now caries a heavy rubber mallet in the truck.

Where do I repair my Chevy fuel pump?

To avoid this, cancel and sign in to YouTube on your computer. Hey there viewers! My name is Eric O. and I own and operate a small town 3 bay shop in upstate NY. I grew up in the automotive industry (in my parents shop) and have over 17 years (working full time as a mechanic) experience repairing domestic and Asian cars and light trucks.

How to test a GM 4.3L fuel pump?

More GM 4.3L, 5.0L, and 5.7L Tutorials. It’s very important that you start off your fuel pump relay diagnostic by first testing the fuel pump pressure with a fuel pressure test gauge. If the fuel pump relay IS NOT activating the fuel pump, the fuel pressure test gauge will register 0 PSI when cranking the engine.

What kind of engine does a 1995 Sonoma have?

I’ve got a 1995 Sonoma with the 2.2 and it suddenly quit while I was driving on the interstate at about 70 mph. I got it home via AAA and found I had plenty of fuel pump pressure as well as spark.

How to replace a fuel pump in a 1995 GMC 5.7?

Replace a fuel pump in a 1995 GMC 5.7. – YouTube Replace a fuel pump in a 1995 GMC 5.7. If playback doesn’t begin shortly, try restarting your device.

How does the fuel pump know when to shut off?

Some vehicles can vary the voltage to the fuel pump to control fuel pressure. In the case of an accident, there are many crash sensors on modern cars that the PCM will monitor. When an accident has been registered, the PCM has the option to cut power to the fuel pump by turning off the fuel pump relay. Was this answer helpful?

Replace a fuel pump in a 1995 GMC 5.7. – YouTube Replace a fuel pump in a 1995 GMC 5.7. If playback doesn’t begin shortly, try restarting your device.

How does a GMC Sierra 1500 fuel pump work?

The older model has steel lines coming off of the top of the pump to the frame rail and then connects to the frame steel lines with short hoses, you’ll need line wrenches and the ability to curse. The newer style has plastic tubes from the plastic pump casing and uses those quick connect fuel fittings and you’ll need the disconnect tool.

Why does my GMC Sierra suddenly stop running?

Truck suddenly stops running, acting like it’s out of fuel. There is fuel in the gas tank and, I can hear the fuel pump when I turn the ignition on. Is there a fuse, or relay that is maybe causing this to happen?

Where does the fuel pump go in a car?

In modern fuel injected vehicles, the fuel pump sits right in the fuel tank and “pushes” the gasoline to the fuel rail (s). It is in the fuel tank because “pushing” fuel to the fuel rail is easier than “pulling” the fuel, which is what an inline pump would do.

What is the fuel pump relay wiring diagram?

Fuel Pump Relay Wiring Diagram (Automatic Trans. Only) NOTE: The illlustrations and info in this page apply only to 1994 Chevrolet/GMC pickups with a 4.3L, 5.0L or a 5.7L engine. For the 1993 fuel pump wiring diagram, check out the following article: 1993 Fuel Pump Circuit Tests (GM 4.3L, 5.0L, 5.7L).

What are the fuses on a GMC Sierra?

Cruise Control, 4 WD Display Illum. Rear Window Defogger Timer, Aux. Batt. Relay Feed, Safety Belt Buzzer Timer, Cluster Ign. Feed Ign. A Dome Lamp, Cargo Lamp, Ctsy, and Glove Box Lps.

What are the symptoms of a bad fuel pump?

Also, the symptoms are almost exactly the same as bad/clogged fuel filter. Here are the most common symptoms of a bad fuel pump in your GMC Sierra: One of the most common signs that a fuel pump is going bad is a whining sound. The whining sound can indicate that the fuel pump is going out before there are any performance based issues.

Can a GMC Sierra run without a fuel pump?

Without gas your Sierra will not run at all. With that in mind, most of the symptoms of a bad fuel pump revolve around the vehicle stalling out or not running at all. In modern fuel injected vehicles, the fuel pump sits right in the fuel tank and “pushes” the gasoline to the fuel rail (s).

What happens if you run your fuel pump all the time?

The fuel pump run continuously with your engine, delivering high-pressure fuel to the fuel rail and injectors. The fuel pump keeps cool by staying submerged in fuel or else it would overheat. If you make a habit of running your tank all the way to empty before filling up; your fuel pump will most likely die before its designed lifespan.

Can a bad FPR cause a fuel pump misfire?

If yes, bad fpr, injector leaky and fuel pump check valve could be culprit. P1406 is for the EGR valve. Different issue from fuel pressure drop. EGR or passages could be blocked by carbon buildup. Intake leak, injector and fpr leak can cause P0300 multiple misfire though.

Where is the ground wire on a Silverado?

Yes, and that connector is grounded to a stud on the inside upper far right of the firewall. That should only affect the HVAC system though. If nothing in the truck is working check your negative cables on the battery and starter. Also check the body ground strap on the frame just forward of the firewall on the passenger side.

What causes a bad gas gauge on a Chevy truck?

A poor ground or loose connection to a gas gauge is just as likely to cause problems as loose or dirty battery cables assuredly will with your starting system.

What to do if your fuel gauge is full?

If you DO have 12 volts to the fuel gauge, the next step is to remove the fuel sending unit wire, and, with the ignition key “on”, ground the sender wire to a good chassis ground. The fuel gauge should immediately go to empty. Removing the sending unit wire from the chassis ground the fuel gauge should go directly to “full”.

A poor ground or loose connection to a gas gauge is just as likely to cause problems as loose or dirty battery cables assuredly will with your starting system.

Why does my truck not start after a fuel pump replacement?

WELL I COULD HERE IT COME ON BUT NO GAS COMING OUT OF THE FUEL LINE WHERE I DISCONNECTED THE FUEL FILTER LINE TO CHECK IF IT WAS PUMPING GAS TO THE ENGINE AND NO LUCK !!!! SO HERE IS THE DEAL ON THIS PROBLEM WELL TWO OF THE WIRES WERE CROSSED !!!!

Why is the fuel pump and relay not working?

The ignition circuit, which includes the ignition switch, controls power to many components, including the fuel pump and relay. If there is an issue with the switch or the circuit, perhaps a wiring problem, then power to the fuel system may be cut off.

Where does the gas go after a fuel pump replacement?

IT SAID GRAY FROM MY OLD HARNESS GOES TO THE SMALL BLACK WIRE TO NEW HARNESS WHICH WAS WRONG !! SO WHEN I REWIRED IT GRAY TO GRAY ! IT PUMPED GAS RIGHT THRU THE FUEL LINE GOING TO THE FUEL FILTER LINE RIGHT AWAY !!

Why does my fuel pump not start when I change it?

You always want to replace the fuel filter when replacing the fuel pump. This could cause the concern you are having. It may seem as you are getting enough fuel from the pressure regulator but if the pressure from the fuel tank is not correct, it will still not start. Another problem you could be having is spark.

What kind of pump does a 96 Silverado use?

I have a 96 Silverado 1500, and it did the exact same thing. It would fire with starting fluid after a line, filter, relay and pump replacement. It turned out the pump I put in was for a 96 C1500, which has a throttle body system and the pump only produced 20-30psi.

What kind of fuel pump does a Chevy Silverado need?

It turned out the pump I put in was for a 96 C1500, which has a throttle body system and the pump only produced 20-30psi. The Fuel injection in the Silverado needs 55-65psi. Be very careful you didn’t put the wrong fuel pump in!!

Where to check for no start fuel pump?

The first thing you want to do is check the fuse panel to see if the fuse is blown. If your car has two fuse panels than the one in the engine compartment; should be the correct one to check. The fuse panel or circuit box is usually located near the battery; and is a small black box with a removable lid.

What happens when there is no fuel in the fuel pump?

This also verifies that the engine has no fuel pressure. Electric fuel pumps on electronically controlled fuel injection systems need to produce enough “high” pressure to allow the injectors to produce a sufficient spray of atomized fuel into the intake path (or into the combustion chamber in a direct-injection system).

Which is the best GMC fuel pump on eBay?

Hassle Free Returns. Free Fast Shipping. 2.0 out of 5 stars. 4.5 out of 5 stars. 5.0 out of 5 stars. 5.0 out of 5 stars. 5.0 out of 5 stars. Highest Quality, Best Value, Guaranteed! 4.0 out of 5 stars. Hassle Free Returns. Free Fast Shipping. 5.0 out of 5 stars.

What causes a fuel pump to die before filling up?

If you make a habit of running your tank all the way to empty before filling up; your fuel pump will most likely die before its designed lifespan. This is due to the fact that when you shut off the engine with a low fuel level; the fuel can drain from the priming chamber designed into the fuel delivery system.

What should I do if my fuel pump is not working?

Fuel pump breakers usually have a button on top that pops up when it trips. Simply push this button back in until it clicks. Check the owner’s manual for the exact location. Fuel Pump Testing – If the fuse is good and the circuit breaker is not tripped; then the engine is not getting fuel pressure.

Why is my fuel tank collapsing on my GMC Sierra?

I’m also having this problem with my 2000 GMC Sierra SL c2500 5.7. It creates a vacuum and collapses the fuel tank. Im on my third fuel tank but didn’t realize at first a vacuum was crushing it. Any ideas? It seems the more I read, the more possibilities that could cause it but its getting expensive with the tanks and pumps.

What are the symptoms of a fuel pump relay problem?

1. Engine stalls One of the first symptoms of an issue with the fuel pump relay is an engine that suddenly stalls. If the fuel pump relay has an issue while the vehicle is operating it will cut off power to the fuel pump, which will cause the engine to stall.

When did I change the fuel pump on my GMC Sierra?