When checking transmission fluid level on a manual transmission What is the proper procedure?
When checking transmission fluid level on a manual transmission What is the proper procedure?
Most of the time, the level of a manual transmission is checked by placing your finger into the filler plug hole and seeing if you get some fluid onto the end of your finger. If you don’t, then the fluid is low. If there is fluid at that level, then no additional fluid is needed.
How to read Trouble Codes for 1993-95 Ford Probe?
How to Read Trouble Codes for 1993 – 1995 Ford Probe Here is a complete list of MECS-II engine trouble codes, taken from “How to Understand, Service and Modify Ford Fuel Injection & Electronic Ignition Control.” I offer this as a FAQ for those with 1993-95 Probes.
How does the Check Engine light work on a Ford Probe?
The check engine light will blink out the trouble codes. Below is an explanation of how the light shows the codes and some other notes. Interpreting the check light: LONG PULSE – (1.2 seconds) counts off the first digit (or tens position) in code SHORT PULSE- (0.4 seconds) counts off the second digit (or ones position) in code
Where is the GND pin on a 1993 Ford Probe?
I offer this as a FAQ for those with 1993-95 Probes. Basically, you can use a wire or a large paper clip to connect the GND pin to the TEN pin on your diagnostic connection. The connection is located in the front driver side corner under the hood, between the fender and the battery.
How long is a long pulse on a Ford Probe?
LONG PULSE – (1.2 seconds) counts off the first digit (or tens position) in code SHORT PULSE- (0.4 seconds) counts off the second digit (or ones position) in code Long pulse and short pulse sections are separated by 1.6 second gap, individual pulses separated by a 0.4 second gap, and codes are separated by a 4 second gap.
What kind of transmission does the Ford Probe have?
Two automatic transmissions were available in the Probe. At first both engines shared the same automatic transmission, the Ford F-4EAT transmission, but from 1994 onwards this changed. The V6 engine continued to use the 4EAT, but the 2.0 L I4 engine used a different automatic transmission, the Ford CD4E transmission.
What was the SE package on the Ford Probe?
For 1993 and 1994, Ford offered a “SE” appearance package on the base model Probe. The package offered 3 spoke swirl-style alloy wheels, the GT model’s ground effects, and the GT model’s front bumper. Unlike the base, you were able to opt for power windows and mirrors on the SE package.
When did Ford discontinue the Ford Probe?
On March 17, 1997, Ford announced the discontinuation of the Probe. Starting in the late 1970s, Ford and Ghia started exploring a series of futuristic designs with the “Probe” series of concept vehicles.
When did the Ford Probe GT Plus come out?
In 1994, Ford released a limited edition of the Probe, marketed as the Probe “Feature Car”, but officially called the “GT Plus” package. This special package is better known to the general public and enthusiast community as the Probe “Wild Orchid Edition”.
