What was the problem with my 2008 Chrysler 300?
What was the problem with my 2008 Chrysler 300?
The contact owns a 2008 Chrysler 300. The contact stated that the vehicle failed to start. The vehicle was taken to the dealer. The technician diagnosed that the module transmitters needed to be replaced. The vehicle was repaired; however, the failure recurred.
Are there any brake ABS problems in the Chrysler 300?
Chrysler 300 owners have reported 12 problems related to brake abs warning light (under the service brakes category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Chrysler 300 based on all problems reported for the 300.
When did Chrysler start the anti theft system?
Chrysler anti-theft systems have gone through a few iterations. Starting in 1989, Chrysler started installing them on the C, G, and J body styles. The engine controllers in that era were referred to as SMEC (single module engine controller).
When did Chrysler start using the SMEC system?
Starting in 1989, Chrysler started installing them on the C, G, and J body styles. The engine controllers in that era were referred to as SMEC (single module engine controller). The SMEC communicated with the body control module (BCM).
What should I do if my Chrysler 300 wont start?
Turn the key and nothing happens. No lights on dash work (accessory lights) ac and cd player dont work either. Headlights, interior lights, trunk lights all good. I have checked battery, starter, and looked for loose grounds. Thinking it might be ignition switch, but hoping someone on here has had a similar issue.
What kind of lights work on Chrysler 300?
No lights on dash work (accessory lights) ac and cd player dont work either. Headlights, interior lights, trunk lights all good. I have checked battery, starter, and looked for loose grounds.
Why does MY BMW 300 not start when I turn the key?
This just means that the engine doesn’t move when you turn the key. The second way that your 300 won’t start is when the engine turns when you engage the starter, but it won’t fire and run on its own. When the engine isn’t turning over at all, that’s a bit easier to diagnose than when it is cranking but not firing.
Where is the IoD fuse on a Chrysler 300?
Remove the IOD fuse, It’s the fuse enclosed in a black or clear holder in the fuse block in the trunk. It wont come all the way out, just squeeze the tabs on the sides and lift it up about 1/4 inch to disengage it. (if you are confused you can find detailed info on the location of the IOD fuse in your owners manual)
