Most popular

What to do if your GMC Envoy wont start?

What to do if your GMC Envoy wont start?

You’ll be leaving the ignition on so as an option hook up a battery charger . 1.Turn the key to on and attempt to start engine ( it won’t start I know) leave the ignition in the on position do not turn it off ,you see the security light flashing or just staying on ?your gonna wait about 10 minutes for that sucker to turn off.

How many people have commented on the GMC Envoy?

Go to the next comment I’ll post it on there don’t worry it’s easy as heck . 35 people found this helpful.

How often does my GMC Truck turn over?

So far this has been the case pretty much every time i am starting the truck cold. I’ll try to start it and it will turn over for about 3-4 seconds (have tried a bit longer, still no go) then i’ll stop and try to start it again, and the second time it fires right up.

What to do when your GMC Truck won’t start?

Try turning your key to the run position a few times (with out starting). Then try to start it. If it starts, sounds like what mine did. I replaced the fuel pump assembly and that fixed the problems. Very common problem.

What does it mean when your GMC Envoy won’t start?

The first and most common is when it won’t turn over. This just means that the engine doesn’t move when you turn the key. The second way that your Envoy won’t start is when the engine turns when you engage the starter, but it won’t fire and run on its own.

So far this has been the case pretty much every time i am starting the truck cold. I’ll try to start it and it will turn over for about 3-4 seconds (have tried a bit longer, still no go) then i’ll stop and try to start it again, and the second time it fires right up.

Try turning your key to the run position a few times (with out starting). Then try to start it. If it starts, sounds like what mine did. I replaced the fuel pump assembly and that fixed the problems. Very common problem.

Theres a code you have to do Turn the ignition over without starting it, push the gas pedal down all of the way three times within 5 seconds, and the light should go off. Then start it to make sure. If this does not work, repeat procedure.

Are there any problems with the 2005 GMC Envoy?

TL* THE CONTACT OWNS A 2005 GMC ENVOY. WHILE DRIVING 50 MPH, THE CONTACT DISCOVERED A BURNING ODOR. THE CONTACT ATTEMPTED TO LOWER THE WINDOW AND NOTICED THAT THE POWER SWITCH FROM THE WINDOW WAS HOT. THE CONTACT DISCONNECTED THE POWER SWITCH.

What happens to the gas gauge on a GMC Envoy?

THE GAS GAUGE STAYS ON EMPTY WHEN THERE IS A FULL TANK OF GAS. THERE REAR WINDSHIELD WIPER COMES ON BY ITSELF. THE RADIO PLAYS LIKE IT IS IN A TIN BOX. EVERY SO OFTEN IT WILL PLAY NORMAL.

Is the GMC Envoy rear lift door working?

It has less than 30,000 miles on it, so maybe I have a while for anything major to happen. 2006 Envoy the light rear lift door works fine. But the two side light do not come on as light or as stop light. Even the tow light connection work ok. How do I go about checking the fuse or relay?

Theres a code you have to do Turn the ignition over without starting it, push the gas pedal down all of the way three times within 5 seconds, and the light should go off. Then start it to make sure. If this does not work, repeat procedure.

Are there any recalls on the GMC Envoy XL?

I have a 2003 GMC Envoy XL and have never owned a car with as many recalls as they have had on the Envoy. The engineering flaws and just plain stupidity are too numerous to list here. 1. Fuel Leak due to rust (partially reimbursed by GM)

It has less than 30,000 miles on it, so maybe I have a while for anything major to happen. 2006 Envoy the light rear lift door works fine. But the two side light do not come on as light or as stop light. Even the tow light connection work ok. How do I go about checking the fuse or relay?

You’ll be leaving the ignition on so as an option hook up a battery charger . 1.Turn the key to on and attempt to start engine ( it won’t start I know) leave the ignition in the on position do not turn it off ,you see the security light flashing or just staying on ?your gonna wait about 10 minutes for that sucker to turn off.

Go to the next comment I’ll post it on there don’t worry it’s easy as heck . 35 people found this helpful.

How to replace the ignition switch on a GM car?

1. Insert ignition key and turn to the “ON” position. Do not attempt to start the engine. Leave the key in the “ON” position for approximately 11 minutes. The security light will be steady on or flashing for the 11-minute period. Do not proceed to Step 2 until the security light turns off or stops flashing. 2.

How long does it take to turn off a GM security light?

Leave the key in the “ON” position for approximately 11 minutes. The security light will be steady on or flashing for the 11-minute period. Do not proceed to Step 2 until the security light turns off or stops flashing. 2. Turn the ignition switch to the “OFF” position for 30 seconds. 3.

When did the GMC Envoy XL come out?

A five-passenger Envoy arrived first as an early 2002 model. In spring 2002, GMC added an extended-length, seven-passenger Envoy XL with three rows of seats. Although Chevrolet will keep its prior Blazer around for a couple more seasons, GMC has shelved the long-lived Jimmy nameplate.

What kind of steering system does GMC Envoy have?

A new rack-and-pinion steering system delivers a 36.4-foot turning circle, claimed to be the tightest in the midsize SUV league. Available in SLE and SLT trim levels, the four-door Envoy sports a trapezoidal bodyside shape and a shield-shaped grille that help give it a distinct identity, though overall appearance is similar to its GM companions.

Why does my GM car say no start no crank?

How to diagnose a no start no click on GM vehicle. If you have a late model GM vehicle and turn the key only to hear nothing, you’ll most likely think you have a dead battery—and you may. But a no start, no crank, no click condition can be far more involved than that.

What’s the problem with GMC Envoy head lights?

I own a 2005 GMC Envoy, so I’ve noticed this problem too, the headlights have flickered and okay no big deal but then Monday night as I drove home the head lights went out. Right as I’m pulling to a stop light, I switch the lights on and off several times, no luck.

What are the problems with a 2004 GMC Envoy?

Top 2004 GMC Envoy Problems 1 Air Compressor for Rear Air Springs May Fail 470 people have reported this 227 2 Fuel Level Sensor Failure 378 people have reported this 214 3 AC Blower Inop Due to Failed Resistor 272 people have reported this 121 4 CD Player In Radio May Fail 175 people have reported this 85

I own a 2005 GMC Envoy, so I’ve noticed this problem too, the headlights have flickered and okay no big deal but then Monday night as I drove home the head lights went out. Right as I’m pulling to a stop light, I switch the lights on and off several times, no luck.

Who is the owner of the 2005 GMC Envoy?

2005 GMC Envoy/Envoy XL/Envoy Denali Owner ManualM GENERAL MOTORS, GM, the GM Emblem, GMC, the GMC Truck Emblem and the names ENVOY, and DENALI are registered trademarks of General Motors Corporation. This manual includes the latest information at the time it was printed. We reserve the right to make changes after that time without further notice.

Is there a GMC Sierra that won’t start?

I have a 2010 GMC Sierra 2 door pick up that won’t start ans is saying to service theft deterant system. I replaced the battery and the truck started and ran fine. No it won’t start again. Any ideas?

Is the ignition switch part of the PCM?

The ignition switch now talks to the body control module (BCM) and it’s the BCM that initiates one of two relays. The second relay, the more important of the two, is controlled by the powertrain control module (PCM).

I have a 2003 GMC Envoy XL and have never owned a car with as many recalls as they have had on the Envoy. The engineering flaws and just plain stupidity are too numerous to list here. 1. Fuel Leak due to rust (partially reimbursed by GM)

How does the ignition switch work on a GM car?

The ignition switch now talks to the body control module (BCM) and it’s the BCM that initiates one of two relays. The second relay, the more important of the two, is controlled by the powertrain control module (PCM). And it only operates the starter relay after it’s satisfied that the correct key is in the ignition.

Why does my Gm key not turn in?

The GM (Buick, Cadillac, Chevy, GMC, Hummer, Oldsmobile, Pontiac) ignitions tend to fail because of wear from inserting the key at a slight angle. This is the same for the Chrysler vehicles (Chrysler, Dodge, Eagle, Jeep, Plymouth).

Why does my Toyota Geo not turn on?

The Toyota and Geo ignitions tend to stop turning because of worn keys. A new “code” key or duplicate key may solve the problem. If a new key does not get your ignition to turn then your ignition will need to be worked on. Vehicles Affected

How to diagnose a no start no click on GM vehicle. If you have a late model GM vehicle and turn the key only to hear nothing, you’ll most likely think you have a dead battery—and you may. But a no start, no crank, no click condition can be far more involved than that.

Where can I buy replacement GMC Envoy parts?

That’s why whenever you have to replace a GMC Envoy part, make sure that these GMC Envoy replacement parts would function in the same way the original GMC Envoy part would function. The surest way that you will get top quality GMC Envoy part is to purchase it from an authorized GMC Envoy part dealer.

What was the first name of the GMC Envoy?

The first GMC Envoy was just the nameplate of a more luxurious trim line of the midsize SUV that is the GMC Jimmy. But the Envoy name was destined to be more than that. Throughout its run as GMC’s standalone entry in the midsize SUV market, the Envoy steadily gained ground in the SUV world.

Where do I change the headlight relay on my GMC Envoy?

This is a common problem among many GMC SUVs. What you need to do is change the headlight relay found next to the battery. Look for number 46, take it out, and replace it with a new one. Some stores sell headlight relays as part of a kit, but you can find them sold individually at your local GMC dealership.

Why does my shift shifter not move through gears?

I’d suggest checking the shift linkage on the transmission to see if the cable came off. This is due to the connector end bushing falling apart and not being able to hold the cable on any longer. Some cables have to be replaced as a whole and as with others the bushing can be replaced to fix the cable.

Where can I get a 2002 GMC Envoy?

Aux propriétaires canadiens: Vous pouvez vous procurer un exemplaire de ce guide en français chez votre concessionaire ou au: Helm, Incorporated P.O. Box 07130 Detroit, MI 48207 vii 4-Door Utility About Driving Your Vehicle As with other vehicles of this type, failure to operate this vehicle correctly may result in loss of control or an accident.

What are the symbols on a GMC Envoy?

If you need help figuring out a specific name of a component, gage or indicator reference the following topics in the index: “Engine Compartment Overview” “Instrument Panel” “Comfort Controls” “Audio Systems” Also see “Warning Lights and Gages” in the Index. Here are some examples of symbols you may find on your vehicle:

Where are the power seat controls on a GMC Envoy?

The power seat controls are located on the outboard side of the front seat cushions. Move the front of the seat control up or down to adjust the front portion of the cushion.

When to replace the TPM sensors on a GMC Envoy Denali?

2008 GMC Envoy Denali (short wheelbase), replaced all four TPM sensors in February 2016 with AC Delco sensors. Immediately after replacing the sensors the dash light came back on and the LF stopped reading intermittently, worse when it was colder (below 40F). The truck stays inside in a heated garage.

Why does my GMC Envoy stall in traffic?

I have a 2004 GMC Envoy and came onto the problem of the car stalling when stopped in traffic while in gear. This suddenly happen to my vehicle after I had to changed the battery, although this didnt occur to me until after I solved my problems.

What causes no ignition, or dash lights when turning key?

Q: I have no ignition, or dash lights when turning key. All relays and battery are fine. Dash lights work when headlights are on. I’m thinking its some kind of electrical problem. I got it to start one time with the remote start. After that, nothing. I’ve tried jump box to be sure I have power.

Why does my car not start when I Turn on the key?

This feature is not available right now. Please try again later. One possible reason your car wont start is a bad connection. This is one of those things that is often over looked until after the battery or starter or alternator have been replaced or all of the above. if this happens to you check your battery connections. Loading…

Why are the dash lights not working on my car?

All relays and battery are fine. Dash lights work when headlights are on. I’m thinking its some kind of electrical problem. I got it to start one time with the remote start. After that, nothing. I’ve tried jump box to be sure I have power. All electronic systems work except the dash lights, and ignition.

Q: I have no ignition, or dash lights when turning key. All relays and battery are fine. Dash lights work when headlights are on. I’m thinking its some kind of electrical problem. I got it to start one time with the remote start. After that, nothing. I’ve tried jump box to be sure I have power.

This feature is not available right now. Please try again later. One possible reason your car wont start is a bad connection. This is one of those things that is often over looked until after the battery or starter or alternator have been replaced or all of the above. if this happens to you check your battery connections. Loading…

Are there any problems with the GMC Envoy ignition switch?

GMC Envoy owners have reported 44 problems related to ignition switch (under the electrical system category). The most recently reported issues are listed below. Tl the contact owns a 2006 GMC Envoy.

Why does my 2003 GMC Envoy not start?

I got in my 2003 Envoy yesterday and it would not start. The panel went crazy and the CD changer started rotating. The seat adjusted when I put in the key, but it would not start. So, I called and since the service department was closed I spoke to a dealer who said it might think it is being tampered with and to wait 10 minutes.

What happens to the crank sensor on a GMC?

The crankshaft sensor on GMC vehicles is synced to the powertrain control module, or PCM. When the crank sensor is replaced, it must be resynced to the PCM. Without resyncing, the PCM cannot properly determine the position of the crankshaft.

Author Image
Ruth Doyle