What size clutch do I need for my go kart?
What size clutch do I need for my go kart?
Go-kart chains come in different sizes and the size requirements depend on the size of your rear sprocket and clutch sprocket. Always ensure that the clutch sprocket and the rear sprocket require the same chain size. You’ll see that in most cases, go-kart clutches are compatible with a #35 chain or #40/41/420 chains.
How much weight can a centrifugal clutch handle?
A centrifugal clutch is designed to be able to move a certain amount of weight. Once the weight limit is exceeded, then the life of the clutch will be shortened. A good rule of thumb is the kart and driver (and passenger when it is a two seat kart) should not exceed 400 pounds.
How much does a centrifugal clutch cost?
Go Kart Clutches and Parts
| Centrifugal Clutches | ||
|---|---|---|
| SKU | Description | Price |
| 115485 | CLUTCH 3/4″B 12TOOTH #35 CHAIN | 19.50 |
| 115487 | CLUTCH 3/4″B 10TOOTH 40/41/420 | 19.50 |
| 115484 | CLUTCH 5/8″B 11TOOTH #35 CHAIN | 19.50 |
Does a Go Kart need a clutch?
Most off-road and racing go-karts use a transmission, unless they have a direct drive configuration. You’ll most likely come across go-karts that use a torque converter or a clutch, as a transmission. When it comes to transmissions, there is a long-standing battle between torque converters and clutches.
How long will a centrifugal clutch last?
If it’s installed on the engine crankshaft properly, without using the “magic hammer” to pound it on the shaft, using the right length key (1/2″) and observing all the hints that are pointed out in this article, a clutch should last several years.
What better 10 or 12 tooth clutch?
10t is like a lower gear. Better pulling power. 12t is a higher gear, faster top speed.
What kind of clutch does a go kart use?
Go Kart Clutches and Mini Bike Clutches in 5/8″, 3/4″ and 1″ Bore. American made Max-Torque Clutches, Comet Clutches and Hilliard’s Extreme Duty Clutches. Centrifugal Clutch Bushings and Sprockets. We also stock Centrifugal Pulley Clutches, Go Kart Clutch Keys, Keystock, Rebuild Kits and Set Screws.
How much chain does a 10 tooth clutch use?
The 10 Tooth Clutch uses 40, 41, 420 Chain. Max-Lube Clutches were developed in conjunction with Chuck Brister, a major kart manufacturer here in Louisiana, to address one of the most frequent problems with fun karts – lubrication of the clutch bushing.
Can you roll a go kart back forward?
Once in the kart, you can roll it backwards with your hand or foot to get the kart in a position to drive forward. During assembly at the kart factory it’s possible that too much tension was placed on the throttle linkage causing the engine to idle above 2,000 rpm (the starting speed of the clutch for engagement). Think and stress safety.
Which is cheaper a new clutch or a new chain?
A new chain is cheaper than a new clutch. The clutch is an automatic transmission that is activated by the increased rpm of the engine. The clutch should not engage when the kart is at idle. The engine manufacturer sets the idle speed of an engine at the factory.
