What should torque be for rear axle flange?

After having my driver’s side rear axle seal replaced – it is leaking around the flange. The dealer said that this doesn’t have a torque spec – but everything has a torque spec. (doesn’t it?). Anybody know what the torque should be for these bolts?.

What are torque specs for Chevy 3500 Silverado?

Chevy dealer said a hole is worn in the … read more I am replacing the rotor on a 2004 chevy 3500 silverado truck with duallies and need to know the torque specs on the shaft bolts. I cannot find … read more I’m looking for bolt torque specs for an 84 Chevy truck diferential.

Do you need torque specs for 14 bolt axles?

07 classic sierra 2500hd, 4.10’s 10.5″ rear 14 bolt full float. Had to pull the axles to balance the tires on the truck. Need to know the torque specs. I’m pretty sure they’re the same for 04-07classic. I just gotta ask: Why did you have to pull the axles just to balance the wheels?

What kind of torque does a 2004 Chevy Silverado have?

Vocational, Technical or Tra… Vocational, Technical or Tra… Vocational, Technical or Tra… I own a 2004 SilveradoXXXXXtruck. I started having a loud clunk when shifting the automatic transmission.

What should the torque be on A 2500HD rear hub?

Tighten the adjusting nut to 70 Y (52 lb ft). Turn the adjusting nut counterclockwise until the nut is loose using the J 2222-C. Turn the adjusting nut clockwise until the nut contacts the bearing cone. Torque on the nut must be zero to finger tight. Thanks, I knew it was something like that because nut was kind of loose when I took it off.

What are torque specifications for Chevy axle nut?

2012-2017 There are two types of wheel drive shaft nuts, both of which have different tightening torque specifications. Check the style nut that is on the vehicle when staking the nut. Style 1 nut has the thin collar (1.5 mm) thickness. Style 2 nut has the thick collar (2.7 mm) thickness.

How much torque does an axle shaft have?

Coat the axle shaft bolt threads with waterproof seal and install them by hand untill they seat. Do not tighten them at this time. 38. Tighten wheel lugs to 140ft/lbs (190Nm) 39. Now tighten the axle shaft bolts to 60-80ft/lbs (81-108Nm)

What kind of nuts to use for axle flanges?

The axles with wedges will tend to stay tight and not leak with less torque but I still hit them all the same. Oxbow, snowman_w900, SAR and 3 others Thank this. I use nyloc nuts and 180 ft/lbs. I have used Stover lock nuts in past, but they always seem to damage stud threads or pull studs out of hub when removing.

Where can I find the torque specification guide?

Ensure that you have the correct torque for the application by referring to SKF 457377 torque specification guide or contact the vehicle manufactures dealer. It is important that you properly torque the spindle nut to ensure optimum bearing life. Under torque of an axle nut will allow excessive movement causing uneven loading and excessive wear.

Where do I Find my flange bolt torque?

All values other than suggested torque amount are sourced directly from flange bolt charts and flange torque charts in the ASME B16.5 “Pipe Flanges and Flanged Fittings: NPS 1/2 through NPS 24 Metric/Inch Standard” (2017).

What should torque be for rear axle flange?