What should the temperature be at the pressure gauge?

What should the temperature be at the pressure gauge?

Over 200 degrees F. we’re at risk of spilling at the pressure temperature relief valve. Typical operating temperature observed at the gauge will be below the high, and can be as low as nighttime room temperature in non-heating season if no tankless coil is in use.

What should the CVT fluid temp be at?

1. Park the vehicle on level ground (engine running, parking brake set). 2. Using a scan tool, ensure that the CVT fluid operating temperature is within the range of 170°F-180°F (77°C-82°C). 3.

Where can I get a CVT fluid gauge?

Special tools CVT Oil Level Quick Check Gauge (J-51155) and CVT Charge Pipe Cap Release (J-52611) are now available from Nissan and dealers, Figure 1 and 2. Also, tools can be obtained from Tech-Mate at 1-800-662-2001. Figure 2.

What is a normal reading for the oil gauge?

Gauges that register in PSI, usually range from 0 to 100 and the normal zone on these is between 20 and 80 PSI. The oil pressure gauge measures the resistance to the oil being pumped through the engine by the motor’s oil pump. The temperature of the oil, the type of oil and it’s viscosity all affect that resistance.

How big is a fluid level temperature gauge?

Fluid level/temperature gauges are available in 3 sizes each with 2-hole mounting at 76mm, 127mm and 254mm mounting centres. The high- visibility viewing lens is a one-piece design for added security, moulded in shatterproof, transparent polyamide. Product Features:

What’s the quick check gauge for CVT oil?

Tool CVT Oil Level Quick Check Gauge (J-51155) can now be used to determine the CVT fluid level. The handle on tool J-51155 has two positions, red and blue (see Figure 6 and 7 ). Refer to Table A for the correct position for a given vehicle.

1. Park the vehicle on level ground (engine running, parking brake set). 2. Using a scan tool, ensure that the CVT fluid operating temperature is within the range of 170°F-180°F (77°C-82°C). 3.

What should the WS ATF level gauge read?

SST: 10002-00101-1 SST: 10002-00101-6 Figure 6. NOTE Ensure the sliding tube is fully retracted into the gauge housing before inserting into the transmission inspection port. HINT The level/measurement indicator on the WS ATF Level Gauge will read 0 mm when the sliding tube is fully retracted.