What oil does a 2004 Ford Ranger take?
What oil does a 2004 Ford Ranger take?
5W-30
Engine Oil
| Viscosity: | 5W-30 (All TEMPS) |
|---|---|
| Capacity: | 5 quarts (with filter)When refilling, remove dipstick to provide adequate venting and allow oil to flow into crankcase. After refill, check oil level. Top off to proper level as needed. |
| Torque: | 19 ft/lbs (Oil Drain Plug) |
How do you reset the oil life on a Ford Ranger?
Press the right arrow button, then from this menu scroll to the VEHICLE. Press the right arrow button, then from this menu scroll to OIL LIFE RESET. Then Press OK BUTTON. After you select the the OIL LIFE RESET the remaining PERCENT OIL LIFE is displayed.
What kind of oil does a Ford Ranger take?
If your Ranger is too low to the ground to access your drain plug and oil filter, be sure to use jack stands and safe jacking procedures before getting under your Ranger. Most Fords have the oil type printed on the oil cap – it will likely be 5W-20, 5W-30, 5W-40, 10W-30 or 10W-40.
How to change the oil in a Ford Ranger transfer case?
Changing the oil in a transfer case in a Ford Ranger is an easy procedure, requiring minimal effort and equipment. This procedure is done only after many miles are on the vehicle, so it is necessary to do as often as an oil change.
How to change automatic transmission fluid in Ford Ranger?
Discard the old pan gasket. 6. If necessary, remove the Automatic Transmission Fluid (ATF) filter mounting bolts, then remove the filter by pulling it down and off of the valve body. Make sure any gaskets or seals are removed with the old filter. The transmission usually has one round seal and a rectangular gasket.
How often should I change the oil in my Ford Ranger?
Ford recommends 5W-20 and 5W-30 oil for the 2.3L engines on the Ranger. The recommendation for a 2020 Ford Transit Van oil change interval is every 3,000 to 5,000 miles if you use conventional oil, and every 7,500 to 10,000 miles if you use full synthetic oil. Synthetic blend oil change intervals can be somewhere in between.
How to check front axle fluid in Ford Ranger?
The 1998 and newer Ford Ranger uses a different style front axle assembly than the 1983-1997 models. To check the fluid in these differentials, you have to remove the fill plug on the drivers side of the differential.
How do you change a front axle in a Ford Ranger?
3) Use a wire brush to clean the area around the differential. This will help prevent dirt from contaminating the differential housing while the cover is removed. 4) Position a drain pan under the drive axle. Loosen and remove all but two of the cover retaining bolts.
What kind of lubricant do you use on a 1998 Ford Ranger?
Refill the drive axle housing using the proper grade and quantity of lubricant. Install the filler plug, operate the vehicle and check for any leaks. The 1998 and newer Ford Ranger uses a different style front axle assembly than the 1983-1997 models.
