What makes a 91 Chevy surging at idle?
What makes a 91 Chevy surging at idle?
My father in law’s ’91 Chevy was running poorly, so we put new plugs, wires, cap and rotor on it, and it’s running better, but it it still surging at idle. It basically almost dies out, and then surges back to life (probably a little higher than normal idle), then repeats continuously until you apply some throttle.
What makes a’91 TBI 350 surging at idle?
It basically almost dies out, and then surges back to life (probably a little higher than normal idle), then repeats continuously until you apply some throttle. If I had to guess, I’d say it’s a dirty throttle body, or possibly injecters. If it is one of these, what would be the best way to clean them?
What should I do if my engine is surging?
There may be a fault in the computerized engine control system. Check engine control systems with a scan tool. Have a mechanic test the circuits and repair or replace components as required, since this is generally not a DIY job. The fuel filter may be partially clogged. This is an easy fix! The fix: Replace the fuel filter.
Why does my TBI 350 have zero power?
This weekend I put a new idle air control valve and o2 sensor in, and the symptoms still persist. Along with the erratic idle, the engine has absolutely zero power. It stumbles as if it’s missing a couple of cylinders when you accelerate.
My father in law’s ’91 Chevy was running poorly, so we put new plugs, wires, cap and rotor on it, and it’s running better, but it it still surging at idle. It basically almost dies out, and then surges back to life (probably a little higher than normal idle), then repeats continuously until you apply some throttle.
It basically almost dies out, and then surges back to life (probably a little higher than normal idle), then repeats continuously until you apply some throttle. If I had to guess, I’d say it’s a dirty throttle body, or possibly injecters. If it is one of these, what would be the best way to clean them?
What kind of powertrain does a Chevy 350 have?
This Monster Powertrain Package is complete with all the features you need for a reliable Chevy 350 & Automatic Overdrive 700R4 Transmission from a researched and developed combination of components. Questions? Call Us 800-708-0087
Is the Chevy TH350 transmission a serious transmission?
High performance transmission builders and parts suppliers don’t even recognize this as a serious transmission. More complex to build than a TH350 and far more expensive, especially when built up to handle high hp numbers. Having to run a cumbersome throttle value cable to the carb. linkage.
What causes a 1989 Chev crew cab to stall?
I have a 1989 v3500 chev crew cab with a 454. Started stumbling at low throttle, stalling when I came to a stop or any low rpm activity. Checked for vaccuum leaks, reset base idle, tested sensor components, ran Win aldl diagnostics, could not get it to run right.
Can a bad throttle position sensor cause stalling?
Similarly, if your engine struggles to idle efficiently, it could also be a result of a damaged throttle position sensor. Stalling, surging, or hesitating while idling all can be caused by this unassuming sensor. The best way to determine if these issues are caused by your throttle position sensor is to go to the source.
Why does my car stall at low rpm?
The will likely force your computer to stall the engine and only allow it to run at low RPMs, which means the car will only move at slow speeds. This is a safety feature enforced by the computer so that your engine doesn’t get too damaged.
Why does my 91 Chevy 1500 die at idle?
WORKING ON MY 91 CHEVY 1500 4BY4 . MY PROBLEM IS THE MOTOR DIES AT IDLE IT HAS THE 5.7 TBI. WHEN YOU LET THE MOTOR WARM UP IT WILL JUST DIE OUT AFTER ABOUT 5 MINUTES IDLE TIME BUT WILL START RIGHT BACK UP THEN DIE AGAIN MAYBE 2 MINUTES LATER. IF I PUT IT RIGHT IN DRIVE AND GO IT WILL RUN FIND UNTIL I HAVE TO STOP THEN IT WILL DIE OUT AGAIN.
What is minimum throttle position on Chevy 1500?
The minimum throttle valve position is set at the factory with a stop screw. This setting allows enough air flow by the closed throttle valve to cause the IAC valve pintle to be positioned a calibrated number of steps (counts) from the seat during controlled idle operation.
I have a 1989 v3500 chev crew cab with a 454. Started stumbling at low throttle, stalling when I came to a stop or any low rpm activity. Checked for vaccuum leaks, reset base idle, tested sensor components, ran Win aldl diagnostics, could not get it to run right.
Why does my Chevy k1500 stall when gas is released?
I have been working on our 89 Chevy K1500 and am still having an idle issue. The truck idle drops and lopes and occasionally completely stalls. This usually happens when driving slow in town… backing out of parking space, letting off gas when coming to a stop sign or to park etc. It does fine to start and accelerate.
Why is my Chevy Silverado not 4 wheel drive?
Over time, dirt, moisture and corrosion can affect the contacts on the bolts used to attach the wires to the frame. If you have a 2008 Chevy Silverado with 4-wheel drive problems, or a similar GMC or Chevy truck from another model year, replacing the switch will solve the issue.
What was the problem with my GMC pickup truck?
Specifically, the lawsuit claimed the active fuel management (AFM) system, piston rings and PVC system in these vehicles were faulty and caused excessive oil consumption, as well as premature spark plug degradation and engine malfunction.
What happens when engine idle speed is above programmed range?
When the engine idle speed is either above or below the programmed range, the ECU prompts the ISC to either increase or decrease bypass airflow. Naturally, as the IAC prompts the throttle plate to open, engine speed increases. The IAC features a plunger mechanism that may be stuck/sticking.
Why is my C / K 1500 surging at idle?
TPS SENSOR BREAK INSIDE THESE THINGS AND CAUSE IRRATIC IDLE. THE IDLE AIR CONTROL IS ALSO NEXT TO IT PULL THAT AND ENSURE IT ISNT COVERED IN CARBON.IF IT IS CLEAN WITH CARB CLEANER
What causes an engine to idle up and down?
A malfunctioning MAF sensor can cause a wild up/down engine idle speed (say, 0-2,000 rpm). This might be caused by a loose harness connection or by a damaged or contaminated sensing wire. The MAF sensor measures the amount of air flowing through the throttle valve.
When the engine idle speed is either above or below the programmed range, the ECU prompts the ISC to either increase or decrease bypass airflow. Naturally, as the IAC prompts the throttle plate to open, engine speed increases. The IAC features a plunger mechanism that may be stuck/sticking.
What causes rough idle on Chevy 350 engine?
I pushed the throttle lever to the stop and the rough idle seemed to disappear. So I hunted around for a spring to install to pull the throttle linkage to the stop and installed it. There’s the spring installed to pull the throttle linkage back to the stop. So here’s what I figured out was happening to cause the engine to not idle properly.
What is the TBI code on a 1990 Chevy truck?
Consult a service manual or see below for any check engine light code definitions. You can use a late 80’s or early 90’s GM TBI definition. If you have access to a scan tool use a hook up for a 1990 350 cu. in. 5.7L Chevrolet truck. For some scan tools enter VIN 10th“L” 3rd“C” 8th“K”.
Why is my Chevy Silverado running rough at idle?
Really, your Silverado will be running rougher at any RPM, but a misfire will be most pronounced at idle. Spark Plug Wires – While not every model and engine combination of vehicles today comes with spark plug wires (a lot are now coil on plug), if your Silverado happens to have them, they can go bad and cause a rough idle.
How to troubleshoot a Chevy 4.3 engine?
1 Common Problems. A common complaint with the Chevy 4.3 engine is that it doesn’t idle well, it’s loud and makes awkward noises. 2 Idle Air Control Valve and Throttle Conrtol Switch. Open up the hood and look at all the wires, spark plugs, tubes, vacuum lines and valves. 3 Check Your Oil. 4 Vehicle Fuilds. …
What causes hesitation and surging on Blazer 4.3L?
Fix Hesitation and surging on Blazer 4.3L If you have Hesitation and surging on Blazer 4.3L and it’s driving like a dog—poor acceleration, hesitation, or a surge and you suspect a fuel problem, you may be partially right.
What causes a Chevy 4.3 engine to stall?
Lack of oil will cause a knocking sound in the engine, stalling, poor acceleration and eventually engine break down. Lack of transmission fluid, battery fluids, radiator and cooling system fluids can all cause symptoms that mimic bad idle air control valves and throttle control switches.
Why is my Chevy 4.3 engine still running?
Checking your vehicle’s fluid levels is always a good idea to maintain the overall longevity of the engine. Once you have ruled out all the basics, you can go back to what the Chevy 4.3 engine is known for: bad idle air control valves and throttle control switches.
Fix Hesitation and surging on Blazer 4.3L If you have Hesitation and surging on Blazer 4.3L and it’s driving like a dog—poor acceleration, hesitation, or a surge and you suspect a fuel problem, you may be partially right.
Where is the idle control valve on a Chevy Vortec?
The idle control valve sits on the throttle body and is responsible for adjusting the amount of air that enters the engine at idle, ultimately controlling engine idle speeds. At idle, the valve blocks a small amount of air from entering the engine, keeping idle RPM’s low.
What are the symptoms of a bad idle control valve?
$0.00 1 Irregular idle speed One of the most common symptoms commonly associated with a problematic idle air control valve is irregular idle speed. 2 Check Engine Light comes on Another symptom of a potential issue with the idle control valve is an illuminated Check Engine Light. 3 Engine stalling
Is the engine idles fine but no power on acceleration?
This is for a 1995 chevy s10, 2.2L four cyclinder, automatic and regular body style with approximately 170 K miles. After every long trip I have to top off the engine oil. Now, I smell burnt oil and it loses power when driving and also idles rough. Also, on your conclusion, what would be a estimate ( by average ) for repairs. helpful?
What are the problems with a 1990 Chevy c1500?
Unresponsive to gas peddle at times and has major dead spots. not sure if its the injectors or the timing or if i need a tps sensor Clicking this will make more experts see the question and we will remind you when it gets answered. problems so far: injectors shot turck was pissing gas the second the lines pressurized. 2. TPS code 22 low voltage 3.
Consult a service manual or see below for any check engine light code definitions. You can use a late 80’s or early 90’s GM TBI definition. If you have access to a scan tool use a hook up for a 1990 350 cu. in. 5.7L Chevrolet truck. For some scan tools enter VIN 10th“L” 3rd“C” 8th“K”.
This weekend I put a new idle air control valve and o2 sensor in, and the symptoms still persist. Along with the erratic idle, the engine has absolutely zero power. It stumbles as if it’s missing a couple of cylinders when you accelerate.
What causes idle on a Great Lakes 4×4?
Take the egr valve out and see if there is a piece of carbon stuck in it. This would cause a rough idle. Also make sure the gasket is not leaking around the base of the egr valve. These would both cause the symptoms that you are experiencing.
How to reset the idle speed in a GM TBI?
Unplug the IAC valve located on the passenger side, rear of the throttle body. Start the engine. Insert a T-30 size Torx driver into the Idle adjustment screw that is located behind the plug removed earlier. Turn the screw to adjust the idle speed to 650 RPM +/- 50 RPM.
Unplug the IAC valve located on the passenger side, rear of the throttle body. Start the engine. Insert a T-30 size Torx driver into the Idle adjustment screw that is located behind the plug removed earlier. Turn the screw to adjust the idle speed to 650 RPM +/- 50 RPM.