What kind of transmission has a transfer case?

What kind of transmission has a transfer case?

Transfer Case Identification Guide S tandard transmissions, which once were found in 100% of all cars and trucks produced, now occupy 18-20% of the overall US mar- ket. Transfer cases, which once occu- pied only a fraction of the market, have grown exponentially.

Where is the front output shaft located on a transfer case?

Determine which side of the vehicle the front output shaft is situated on. Some models of transfer cases come in right and left hand drive versions for the same vehicle line. (Figures 10, 11)

Where is the seal on a transmission pump?

The seal, which is usually located in the transmission pump, fits over the snout of the torque converter. Although not as common as some other issues, it’s possible for a fluid leak to develop from a cracked or porous transmission housing. When the housing is damaged, the fix is usually to replace (rather than rebuild) the transmission.

How to identify a 604 transfer case Assembly?

604 Transfer Case Assembly: Figure 12-13 28 GEARS March 2002 Figure 5 Output shaft spline count The output shaft must match the rear drive shaft. Type of yokeon the output shaft (slip yoke, bolt on yoke) Output Splines Type of flangeon front and rear output shafts (round flange or U Joint). This covers a broad area.

Where can I find the transmission identification number?

You will find it on the rear side of the transmission on the passenger side. It can be pretty tough to see on older cars, so you may have to clean up your transmission to find it. If you can see it correctly, you will find an identification number of 7-8 letters and numbers.

What kind of transfer case does a 999 Wrangler use?

The 999 were used exclusively behind the Dana 300 transfer case in 1980-1986 CJ Jeeps. Later Wranglers would use the NP231 transfer case. Both of these transfer cases utilized the round circular 6 bolt pattern still in use today. The output shaft of the 999 always used a 23 spline shaft and a somewhat long transfer case adapter.

How big is a 999 transmission in a CJ Jeep?

The 999 transmissions found behind the standard 258 in the CJ jeeps will not have this provision. The 999 is relatively short at 16.5” in over length; however, the tailhousing section adds an additional 6.125”. This makes the Jeep 727 an overall length of 22.625”.

How much torque can a 700R4 transmission handle?

The transmission is pretty reliable and can handle torque up to around 350nm~; remember that there are only reported numbers, and it can differ a bit. A lot of you reported that you wondered what the differences are between a k-case and the typical case for the 700r4 transmission.