What kind of release bearing do I need for Ford Type 9?
What kind of release bearing do I need for Ford Type 9?
Currency conversions are estimated and should be used for informational purposes only. This kit utilises a concentric release bearing and aluminium boss, replacing the standard gearbox nose. The kit comes completed with replacement seal and fixings.
Where is the release bearing on a clutch?
The clutch thrust bearing (also known as the release bearing or the throw-out bearing) is a small but important part of your car’s clutch system. It is mounted on the housing of your clutch and slides on a hollow shaft. Attached to the clutch bearing is the clutch fork, which moves the clutch bearing with the help of hydraulic or cable pressure.
What should the torque be on a Ford front bearing hub?
The required torque, according to the Ford service manual, is 300Nm. Again, I used one hand to ensure that the socket wouldn’t slide off the hub nut. I used my torque wrench because I’m being picky, but I’ve never seen a taxi mechanic use one.
What are the symptoms of BA / BF front bearing hub replacement?
Symptoms: a growling sound coming from the front of the car. The sound will also decrease as the car swerves or turns to one side. This job was done on a car that will hopefully become a taxi in the near future (if/when I can find a plate to lease), so it will cover standard BA/BF Falcon stuff instead of my usual Brembo brake setup.
How much does it cost to replace center bearing on FG XR6 Turbo?
The centre bearing on my tailshaft on my 09 fg xr6 turbo ute is stuffed. Knocks under load.. My local dealer quoted me $1700 for a replacement tailshaft plus fitting.
How to get Ford Falcon XR6 replacement bearing?
Once you’ve watched the video, please call Dean directly on 0415 636 901 and he’ll guide you through the next step. Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer.
How much does it cost to replace a tail shaft bearing?
I had my tail shaft centre bearing cut out and a bf centre bearing put in, along with thick walled shafts. Including labour it was $1200. Just go to a tail shaft specialist. The bf centre bearings are replaceable I think a quick fix, flog it and get a new one is on the cards.
Can a centre bearing be replaced at the same time?
If it has circlips holding the caps in place your in luck can be pressed out, remove the yoke and replace the centre bearing, also be a good idea to replace the uni at the same time If it’s got little crimps into the steel holding the uni caps in, you need to take the shaft to a driveline shop for them to do it
