What kind of antifreeze does a 2008 Dodge Ram take?
What kind of antifreeze does a 2008 Dodge Ram take?
Prestone 50/50 Coolant/Antifreeze.
How do you drain the radiator on a 2008 Dodge Ram?
Locate the radiator’s drain valve on the bottom of the radiator. You don’t need to raise the Dodge Ram since it’s a high truck with enough room for this job. Place a tray underneath the drain plug. Then, using your wrench, loosen the drain valve.
How do you replace the radiator on a Dodge Ram?
3-4 gallons of 50/50 mixed coolant (use HOAT (Mopar) coolant if that is what your truck has installed) Remove the negative (black) cable with a 10mm wrench. Place the cable in an area it cannot accidentally contact the battery, or wrap the cable with electrical tape. Then, place a drain pan under the radiator.
Where is the power steering cooler on a Dodge Ram?
Remove the transmission and power steering coolers from the radiator. At the bottom of the radiator mounts the power steering cooler. It is held in place by two bolts at each end of the cooler. Access to the bolts is easier from the bottom of the truck. At the middle of the radiator on the front side is the transmission cooler.
Why is my radiator leaking on my Dodge Ram?
Coolant enters and exits the radiator from the plastic end tanks on the sides of the radiator. When the wrong coolant is used or coolant is not changed in the recommended service interval, corrosion can take place inside the radiator, This can cause internal leaks and clogs.
What should I do before replacing my radiator in my Dodge Ram?
Figure 3. Drain all the old fluid from the radiator. Flushing the system is a really good idea before you install the new radiator. Antifreeze is deadly to pets and very toxic to humans. It is also very slick. Clean up any spills immediately; cat litter works well to absorb the nasty stuff.
Remove the transmission and power steering coolers from the radiator. At the bottom of the radiator mounts the power steering cooler. It is held in place by two bolts at each end of the cooler. Access to the bolts is easier from the bottom of the truck. At the middle of the radiator on the front side is the transmission cooler.
Do you have to flush the radiator before replacing it?
Never remove the radiator cap or hoses when the engine is still hot. Flushing the system is a good idea before you replace the radiator, unless this was done very recently. A flush kit makes the job super easy and is a very nominal cost. Make sure you clean up any spills and put the old fluid in an approved container.
Coolant enters and exits the radiator from the plastic end tanks on the sides of the radiator. When the wrong coolant is used or coolant is not changed in the recommended service interval, corrosion can take place inside the radiator, This can cause internal leaks and clogs.
