What is fault code for PT Cruiser Conv 2?

2005 PT Cruiser Conv 2.4 w/turbo. Check engine light comes on then car dies and will not restart without waiting a couple of hours or by disconnecting the battery. Fault codes are P0032 and P0838.I have replace the upstream O2 sensor with no luck. Don’t have the funds for unneeded parts replacement…

What is the p0032 code on a Jeep Wrangler?

I have an ’06 Jeep Wrangler w/4.0l, and at random intervals it throws the following 4 codes: P0032, P0038, P0052, and P0058. They’re “heater control circuit high” for all 4 O2 sensors.

What are the symptoms of a p0038 DTC?

If the PCM detects an abnormally high voltage condition on the heater circuit, P0038 may set. This code is only referring to the heating circuitry half of the Oxygen sensor. Symptoms of a P0038 DTC may include: MIL (Malfunction indicator lamp) illumination There would likely be no other symptoms.

What does p0038 mean on a PCM?

If the PCM detects an abnormally high voltage condition on the heater circuit, P0038 may set. This code is only referring to the heating circuitry half of the Oxygen sensor. Symptoms of a P0038 DTC may include: There would likely be no other symptoms. Potential causes of a P0038 code include:

What kind of circuit is a HO2 sensor?

Faulty Bank 1,2 HO2S (Heated Oxygen sensor) Open in the heater control circuit (12 volt PCM controlled systems) Short to B+ (battery voltage) in the heater control circuit (12 volt PCM controlled systems) Open ground circuit (12 volt PCM controlled systems)

What are the fault codes for ho2s heater?

Fault codes are P0032 and P0838.I have replace the upstream O2 sensor with no luck. Don’t have the funds for unneeded parts replacement…

How to know if your heater sensor is low?

P0031: Oxygen (A/F) Sensor Heater Control Circuit Low (Bank 1 Sensor 1) 1 Signs of a P0031 Error Code. If your vehicle includes an air/fuel ratio sensor, it’s main function is to compare your vehicle’s air/fuel ratio to the outside air. 2 Determining the Cause. 3 Common Solutions. 4 Comprehensive Solutions. …

How to check the O2 sensor on a HO2 heater?

If the battery feed is intact, remove the ground (control) circuit from the ECM wiring connector and check for resistance on the circuit. If there is infinite resistance, repair open in the circuit. If the control circuit checks out, suspect a bad O2 sensor. Replace the sensor and re-check. One example from my experience:

What is the DTC for ho2s heater low?

P0031 is a diagnostic trouble code (DTC) for “HO2S Heater Control Circuit Low (Bank 1 Sensor 1)”.

What is the fault code for a PT Cruiser?

Fault codes are P0032 and P0838.I have replace the upstream O2 sensor with no luck. Don’t have the funds for unneeded parts replacement…

What is fault code for PT Cruiser Conv 2?