What is EEC on a Ford?
What is EEC on a Ford?
The Ford EEC or Electronic Engine Control is a series of ECU (or Engine Control Unit) that was designed and built by Ford Motor Company.
What does a Ford EEC relay do?
The EEC Power Relay not only supplies battery voltage to the fuel injection computer (also known as the E.E.C. Electronic Control Assembly), but also supplies power to the fuel injectors, the fuel pump relay, and a few other emissions related solenoids.
Where can I get an engine control module for a Ford Ranger?
Make sure your easy-to-handle truck keeps going the distance by replacing its broken down computer with a new reliable Ford Ranger engine control module from AutoZone. Your ECM for Ford Ranger controls numerous, essential systems in your truck.
Where does the Ford Ranger engine come from?
The Vulcan was a clean-sheet design using the metric system. The engine block is built by Sherwood Metal Products, the intake comes from Ford’s Essex Casting, and the engine is assembled at Ford’s Lima Engine plant in Lima, Ohio. The Vulcan is a straightforward pushrod design, with 2 valves per cylinder. Bore is 3.504 in and stroke is 3.15 in.
Why does the Ford EEC power relay activate?
As soon as the EEC Power Relay get’s power (on circuit 2 ), the relay activates. The EEC Power Relay activates because its low current circuit is grounded 24/7 (all of the time) by wire 1. In this test section, we’re gonna’ test circuit 1 but there are some very important precautions you have to take:
How to troubleshoot Ford EEC IV engine control?
Place the gear shift lever in Neutral (manual transmission) or Park (automatic transmission). CAUTION – Failure to perform this step may result in the vehicle moving when the starter is subsequently engaged during the test. 2 – Disconnect the S terminal wire at the starter relay.
Make sure your easy-to-handle truck keeps going the distance by replacing its broken down computer with a new reliable Ford Ranger engine control module from AutoZone. Your ECM for Ford Ranger controls numerous, essential systems in your truck.
What kind of fuel pump does a Ford Ranger use?
1991-1994 3.0L V6 Ford Rangers use the EEC-IV electronic fuel injection system. This system uses a fuel injection computer with 60 pins. Fuel pump is inside the gasoline tank. 35-40 PSI (2.5-2.8 Kg/cm²). 30-45 PSI (2.1-3.2 Kg/cm²). 15-18 Ohms (individual resistance). Passenger side, beneath glove box.
Where to buy the tune up parts for a Ford Ranger?
Where To Buy The Tune Up Parts. 1994 was the last year model that the 3.0L V6 Ford Ranger used a mechanical distributor. 0.042-0.046 inches (1.07-1.17 MM). 10° BTDC (before top dead center). NOTE: The inline SPOUT connector must be disconnected.
What does an ECM do on a Ford Ranger?
Your ECM for Ford Ranger controls numerous, essential systems in your truck. Reduced emissions, ideal fuel mixture, easy ignition and variable cam timing all rely on a properly functioning ECM. The Ranger engine control computer is designed to work seamlessly with your truck’s sensors for maximum efficiency and performance.
