What does WS mean on a Dodge Ram?
What does WS mean on a Dodge Ram?
ST is Standard Trim, aka a basic truck. LT or SLT is a Luxury Trim. power everything, carpet, etc. WS is probably Work Special.
What does St stand for on Dodge?
Gunny1963 answered 3 years ago. the st as the other gay said is just a base model truck slandered towing where the slt is a up grade and stands for Standard luxury trim witch comes with chrome bumpers and wheels and trim on the truck also power windows locks and tilt and curse.
What is the difference between an ST and SLT Dodge Ram?
The ST/SXT is the base model. Any of the options could be added to the base model. SLT is a higher optioned model that Laramie options could be ordered. Than the SLT/Laramie model could still have even more options added.
How do you replace a water pump in a Dodge Ram?
If your water pump contains a thermostat, install it into the new pump with the spring end inside of the pump. Some thermostats will have a small tip on the rubber diaphragm facing away from the water pump. This tip needs to sit at the 12 o’clock position. Start the water pump bolts by hand until all are snug.
How to install a water pump on an engine block?
1 Position the new pump straight onto the mounting surface of the engine block. Make sure the bolt holes align correctly. 2 Then, apply a dab of RTV sealant to the bolts and install the bolts finger tight to hold your new water pump in place. 3 Double check that all the bolts are in place and in their original location.
How do you remove a water pump from a car?
If you are removing a drive belt or serpentine belt that runs the water pump, loosen the water pump pulley bolts first, if any. It makes it easier to remove the pulley afterwards. To loosen the bolts, lodge a large screwdriver between two of the pulley bolts and start loosening the other bolt (s).
When to change power steering pump in Dodge Ram 1500?
This article applies to the Dodge Ram 1500 (1994-2008). If you’re the DIY type of person who likes to keep your vehicle running like new, checking the fluid in your power steering pump reservoir is basic stuff. Changing it, if needed, is a no-brainer process that’ll pay off in the long run with the extended life of your Ram.
How does the water pump work on a Dodge Ram?
Also, seals inside of the pump can deteriorate and result in a loss of coolant. This article applies to the Dodge Ram 3rd Generation (2002-2008). The water pump is driven by the accessory belt on the Dodge Ram 5.7, 4.7, and 3.7 engines. The belt turns the water pump pulley that is bolted to the shaft, which connects to the impeller.
How do you replace the fuel pump on a Dodge Ram?
There are several ways to replace the fuel pump. The most common way is by dropping the fuel tank, which will be covered here. The bed of the truck can be tilted or removed. A hole can be cut in the bed directly above the fuel pump as well.
Where is the drain plug on a Dodge Ram?
Take off the radiator cap on the upper passenger’s side corner of the radiator by pushing down while twisting the cap counterclockwise. On the bottom corner of the radiator of the driver’s side is a plug. Turn this plug counterclockwise with a 3/4″ wrench to drain the coolant from the radiator. Figure 1. The radiator drain plug.
Where is the coolant tank on a Dodge Ram?
The washer fluid reservoir sensor connectors and hose on the 3.7 and 4.7 engines. The 5.7 engine coolant recovery tank is located above the radiator. There are two bolts at each side of the tank. Slide any hoses connected to the tank off and be careful as you lift the tank out of the engine bay, or coolant may spill.
