What does the p2138 code in engine control mean?
What does the p2138 code in engine control mean?
What the P2138 code means The P2138 trouble code indicates that the Engine Control Module has detected a malfunction within the D and/or E circuits of the throttle position sensor. What are the causes of the P2138 code? A defective throttle body motor
How to diagnose p2122 Ford throttle position sensor?
Check the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins. How much do you know about cars? The cost of diagnosing the P2122 FORD code is 1.0 hour of labor.
How much does it cost to repair Ford p2122 code?
The cost of diagnosing the P2122 FORD code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
What causes a Ford 6.0L engine to misfire?
Ford Tech Tip: Diagnosing 6.0L Engine Misfire, Lack of Power or No Start Some 6.0L vehicles may exhibit a misfire, lack of power, buck/jerk, excessive smoke or crank/no start. There are several potential causes for these symptoms.
What is the p2138 code on a Pontiac Grand Prix?
Hi all, I have a 2007 Pontiac Grand Prix with sunroof which is throwing code P2138. This has been going on for nearly a year now. When driving in rain or very wet road conditions the Reduced Engine Power message will come on along with the check engine.
Is the p2138 code the same for all commodores?
It is considered generic because it applies to all makes and models of vehicles (1996-newer), although specific repair steps may be slightly different depending on the model.
What does trouble code p2135 mean on a car?
The automotive trouble code P2135 throttle/pedal position sensor/switch A/B voltage correlation refers to a problem related to the throttle’s ability to open and close properly. In the 1990’s automotive manufacturers began industry-wide installation of “Drive by wire” throttle control technology.
What are the sensors on a Chevy p2138?
P2138 Chevrolet Description. The Accelerator Pedal Position (APP) sensor is made up of 2 sensors that are housed inside one assembly. The Engine Control Module (ECM) supplies a separate 5-volt reference circuit and a low reference circuit for each of the sensors.
What the P2138 code means The P2138 trouble code indicates that the Engine Control Module has detected a malfunction within the D and/or E circuits of the throttle position sensor. What are the causes of the P2138 code? A defective throttle body motor
What does trouble code p2128 mean on a GMC Sierra?
The P2128 trouble code refers to Accelerator Pedal Position (APP) Sensor 1-2 Correlation. Do NOT assume you have a bad accelerator pedal sensor. GM says the condition is caused by water leaking into the body harness connector that carries the APP signal to the PCM. The water changes the voltage readings from the APP.
What to do if your p2138 is not working?
Use the scanner to retrieve all stored trouble codes and write them down for future reference. You may also want to keep any related freeze frame data. Your notes may prove helpful if the P2138 is intermittent. Clear the codes and test drive the vehicle. If the code is reset, continue with the diagnosis.
