What does the ignition switch actuator pin do?
What does the ignition switch actuator pin do?
The ignition switch actuator pin allows the vehicle to start when the key is turned by activating the ignition switch.
What’s the Accessory position on an ignition switch?
Insert the key and turn it to the “accessory” position. The ignition switch needs to be set to the accessory position before you can release it from the ignition module. The “accessory” position is before the starter is engaged, and would normally let you run the vehicle’s electronics without the engine running (when the battery is connected).
What kind of screwdriver to use to replace ignition switch?
If you don’t have a small enough screwdriver, you can use anything long and thin enough to press the pin, including a paintbrush handle or even a kabob skewer. Don’t use anything brittle that may break inside the hole to try to press the pin.
The ignition switch actuator pin allows the vehicle to start when the key is turned by activating the ignition switch.
What causes the ignition switch pin to fail?
These particular vehicles and models with years 1995 – 2007 have the ignition switch actuator pin between the ignition lock cylinder and ignition switch and usually fail due to the pin or its components breaking over time preventing the vehicle to start.
Where is the actuating rod on an ignition switch?
The actuating rod links the key cylinder to the ignition switch located under the dash on the steering column. In this case, the small steel pin at the end of the rod that fits into the ignition switch had fallen out and was not moving the switch. Its interesting how a twenty dollar part can shut down a vehicle and cause a hefty towing bill.
Which is Dorman ignition switch actuator do you need?
Dorman’s HELP! line has been helping auto repair professionals and vehicle owners for more than 30 years. With thousands of convenient small parts available almost everywhere, you can quickly get the components you need. Pages with related products. See and discover other items: Ford Freestar Switches
How to disassembly and assembly a Ford Taurus?
20.Install the turn indicator cancel cam. 21.Install the lock cylinder housing screws loosely and position the steering actuator housing in a vise. • Lubricate the lock cylinder housing screws with penetrating and lock lubricant. 22.NOTE: Lubricate the lock cylinder housing bushings with penetrating and lock lubricant.
How to install steering column lock pawl on Ford Taurus?
Install the steering column lock pawl. 1 Position the steering column lock pawl. 2 Drive in the steering column lock lever pin. 34.Remove the steering column upper and lower lock actuator. 3. Install the steering column lower bearing retainer. Assembly 1 Position the steering column lower bearing retainer. 1.
What are the parts of a Ford Taurus?
Install the transmission control selector lever spring clip and the gearshift lever socket bushings on the shift tube. • Coat the gearshift lever socket bushings with premium long life grease. Item Part Number Description 1 — Outer race 2 3517 Bearing (in the ‘‘UP’’ position) 3 — Ball 4 — Inner race 5. Install the ignition switch.
When to replace ignition cylinder actuator rod F150?
Keywords: ford f150 f-150 key ignition accessory start run on in repair replace fix broken broke actuator rod plastic assembly steer steering column starter This procedure is from a 2001 F-150 with power door lock problems.
