Most popular

What does p0017 mean on a Ford F150?

What does p0017 mean on a Ford F150?

P0017 should be considered an important trouble code to diagnose and repair. The crank and cam sensors work in tandem to produce the ideal air/fuel ratio for your engine. When this timing is off, the engine will typically not run (or barely run). Here are the major symptoms of P0017 in the F150:

What’s the trouble code for a Ford engine?

Trouble Code. Fault Location. Probable Cause. P0171. Fuel trim (FT) system too lean, bank 1. Intake/exhaust leak, AIR system, MAFNAF sensor, fuel pressure/pump, injector (s), HO2S. P0300. Random Cylinder Misfire (Cylinder Not Specified) Spark plug (s), HT lead (s), injector (s), ignition coil (s), low compression, wiring.

What is the OBD2 code for a Ford?

OBDII Ford Code Definitions. Be sure to double check the codes. Anything P1000 to P1999 or P3000 to P3400 will be Manufacturer specific and may not match the ones listed here. Check specific manufacturer pages on the site, as some of them, we list the OBD2 codes on those pages for those specific vehicles.

Trouble Code. Fault Location. Probable Cause. P0171. Fuel trim (FT) system too lean, bank 1. Intake/exhaust leak, AIR system, MAFNAF sensor, fuel pressure/pump, injector (s), HO2S. P0300. Random Cylinder Misfire (Cylinder Not Specified) Spark plug (s), HT lead (s), injector (s), ignition coil (s), low compression, wiring.

OBDII Ford Code Definitions. Be sure to double check the codes. Anything P1000 to P1999 or P3000 to P3400 will be Manufacturer specific and may not match the ones listed here. Check specific manufacturer pages on the site, as some of them, we list the OBD2 codes on those pages for those specific vehicles.

How to get diagnostic code for Toyota check engine light?

1 Connect scan tool to the 16-pin data link connector (DLC) located underneath the steering column. The connector may have a removable cover. 2 Turn the ignition on. 3 Follow scan tool manufacturer’s operating instructions to access the Diagnostic Trouble Codes (DTC’s).

What is the code for lost communication with an ECM?

All the ‘U’ codes are network communication codes. Codes U0100 to U0300 are lost communication with XX module codes. U0100 is monitored when the ignition is on, battery voltage is at a certain level and other key modules are configured correctly.

Author Image
Ruth Doyle