What does no Bus mean on a 2005 Dodge Stratus?
What does no Bus mean on a 2005 Dodge Stratus?
It means there there is no communication to the computer,This would be a dealer fix. Nov 21, 2009 • 2000 Dodge Stratus.
Where is the no bus signal on the Odom?
The no bus signal on the odom. Pcm depends on an 8 volt ref to communicate through the bus line to the cluster to operate the dash and to communicate threw the aldl connecter. If any sensor shorts out the pcm goes dead and the no bus sign shows. On the rear drivers side top of bellhousing is the location for the crank sensor.
Is there no bus, no gauges possible solution?
I’d like to offer my solution to the frustrating “no bus and no gauges” problem that I see is pretty common. I have a 2000 ram 1500 2X with the 5.9 automatic, however I believe that this is applies to all gen2 trucks regardless of drivetrain or engine type.
What does it mean when your car says no bus?
Rate this answer: The “no bus” signal is indicating that there is no fuse, a blown fuse, or no power the the ECM (electronic control module or “the brain”) make sure all relays are operational as well and you should be on your way.
What kind of truck has no bus gauges?
I have a 2000 ram 1500 2X with the 5.9 automatic, however I believe that this is applies to all gen2 trucks regardless of drivetrain or engine type. My Story… See the end to get straight to my find. I’ve had my gauges go out with the “no bus’ message in the odometer window three times now!
I’d like to offer my solution to the frustrating “no bus and no gauges” problem that I see is pretty common. I have a 2000 ram 1500 2X with the 5.9 automatic, however I believe that this is applies to all gen2 trucks regardless of drivetrain or engine type.
Why does my Dodge Ram not have an odometer?
If all that checks out unplug the following sensors: Cranks sensor, Cam/SYNC sensor, TPS, MAP and Trans connector. These 5v sensors can short out the CCD bus because they share the same power source. You will have to cycle the key off and on to reset the PCM and CCD bus once you find the problem.
I have a 2000 ram 1500 2X with the 5.9 automatic, however I believe that this is applies to all gen2 trucks regardless of drivetrain or engine type. My Story… See the end to get straight to my find. I’ve had my gauges go out with the “no bus’ message in the odometer window three times now!
Why does my Dodge Ram have no bus?
These 5v sensors can short out the CCD bus because they share the same power source. You will have to cycle the key off and on to reset the PCM and CCD bus once you find the problem. “I’ve usually found that the no-buss on the pickups generally comes from the ABS unit.
