What does MSD Ignition do?
What does MSD Ignition do?
If you’ve been involved in hot rodding for any length of time, you’ll know these infamous letters: MSD. They stand for Multiple Spark Discharge, a patented design by MSD Ignition that fires your spark plug multiple times rather than the single time that the factory ignition does.
Which is the most popular MSD 6 series ignition?
The line of MSD 6-Series Ignitions are the most popular aftermarket ignitions in the world due to our race-proven performance on the track and our reliability on the street! The MSD Pro 600 was designed to have seamless integration with Holley EFI systems!
What to do if your MSD Ignition switch is not working?
If you are using the 2-Pin Magnetic Pickup of the MSD to trigger the ignition, follow these steps. Make sure the ignition switch is in the Off position. Remove the coil wire from the distributor cap and position the terminal so it is approximately 1/2″ from a good ground. Disconnect the MSD Magnetic Pickup connector from the distributor.
Which is power grid ignition system does MSD use?
MSD’s Power Grid ignition system is every bit as capable as a traditional MSD ignition, but offers up tunability that minimizes down time and offers details that allows even the pickiest race tuner to find a setup they like! see more MSD news…
Do you need PN 8910-eis for Sci ignition?
Installation to an MSD DIS-4 Ignition using Four Channels. If a 6 series, 7 series, or SCI ignition was installed, a PN 8910-EIS will be required.
Is there a way to troubleshoot an MSD Ignition?
Troubleshooting your MSD Ignition can easily be accomplished as explained earlier, but if you’re looking for a better way to confirm the operation of the coil, ignition and much more, MSD offers an easy to use hand held Ignition Tester.
How long do MSD 6A ignitions run under load?
Running it along a fender well or the block creates a ground plain for the harness to reduce any electrical interference. MSD has always built the 6A series of ignitions to be as robust as possible. In fact, each ignition is run under load on a test stand for over two hours to ensure full operation.
Why does my MSD Ignition have blue spark?
Down by the plug boots where they meet the plugs, it had blue spark and even when I touched my hand to the wires, you could see the sparks arcing to my hand, but they wouldn’t shock me. Talked to MSD and they said that is the blue corona effect that happens with their ignition systems.
Where to Mount MSD 6A / 6AL ignition control?
Mounting the ignition, routing of the wires and using high quality terminals for each connection are important. The 6A is designed to be installed under the hood but is recommended to be mounted away from direct heat sources such as the exhaust system.
