Most popular

What does high oil pressure mean aviation?

What does high oil pressure mean aviation?

Hear this out loudPauseHigh oil temperature with normal oil pressure. High oil temperatures in flight may indicate something as innocuous as a hot day or poor cooling during a long climb to altitude. Some airplanes just run a little hotter than others. Something may be wrong with the electrical system.

What should I read on oil rail, dt466e?

I have a DT466E with low ICP pressure. New IPR valve, new HPOP, all 6 new injectors, still low ICP. Pulled new HPOP off and had it bench tested, … read more Vocational, Technical or Tra… I have a 2005 international 4300. I have changed the Hi Andy I have a 2005 international 4300.

Is the dt466e a 2001 International Truck?

The Hi, I have a 2001 international truck with the DT466E. The truck was pulling hard up a hill when the warn/engine light came on and it lost power. It has codes 333 and 335. It starts with a wiff of eit … read more

What should the oil pressure be at 3000 rpm?

The ideal oil pressure ranges between 25 to 65 psi when the engine oil is warm and 1000-3000 rpm, whereas if the oil pressure reading shows 80 psi or above then there is some serious problem.

What should the oil pressure be in a semi truck?

For most semi-trucks, the normal operating oil pressure is between 40-50 PSI (pounds per square inch). Keep in mind that it takes around 20 minutes for an engine to reach its maximum operating temperature. The pressure will also drop a little if you’re spending a lot of time idling, too.

How does the high pressure oil pump work on a DT466?

The high pressure oil pump that operates the injectors is fed oil by the lube pump through a reservoir in the front gear cover. When you start a DT466E after an oil change it will start and run for a few seconds and quit then after a few seconds of cranking it will start again and run the oil pressure gauge will start to move at the same time.

I have a DT466E with low ICP pressure. New IPR valve, new HPOP, all 6 new injectors, still low ICP. Pulled new HPOP off and had it bench tested, … read more Vocational, Technical or Tra… I have a 2005 international 4300. I have changed the Hi Andy I have a 2005 international 4300.

The Hi, I have a 2001 international truck with the DT466E. The truck was pulling hard up a hill when the warn/engine light came on and it lost power. It has codes 333 and 335. It starts with a wiff of eit … read more

What are torque specs for high pressure oil rail?

I am looking for the torque and torque sequence for the high pressure oil rail, and the torque specs for the puck that comes out of the oil rail into the top of the injectors. This is on a 2007 emissions Maxxforce Dt in a 2010 4400 International Durastar. Every month 400 people find a job with the help of TruckersReport.

Author Image
Ruth Doyle