What does a check engine light mean on an EGR solenoid?

Check Engine Light comes on. An illuminated Check Engine Light is another symptom of a bad or failing EGR control solenoid. If the computer detects an issue with the EGR solenoid, circuit, or system, it will set off the Check Engine Light to notify the driver of the issue. A bad EGR solenoid can cause a variety of different trouble codes,…

What are the results of the GM EGR valve test?

Check engine light (CEL) will be shining nice and bright. P0401 EGR System Flow Insufficient. P0403 EGR Solenoid Control Circuit. P0404 EGR Open Position Performance. P0405 EGR Position Sensor Circuit Low Voltage. Rough idle. Really bad gas mileage.

What is the Check Engine Light ( CEL ) for?

How many wires are in an EGR valve?

There are 5 wires sticking out of the EGR valve’s connector, in this section we’ll explore what each one does. Most of the EGR valves will have the letters A thru’ E molded onto the EGR valve’s connector. I’ll be using these same letters for the circuit descriptions below: Ground circuit for EGR valve solenoid. Gray with Black stripe wire.

How can I tell if my EGR valve has failed?

You need to confirm whether the EGR valve has failed or carbon deposits have began upsetting EGR system and engine operation. Look for a round, thick, metal disc about three inches in diameter. In most cases, you’ll find it around the top area and to one side of the engine. You may need to look between and under some components on your vehicle.

When does the Check Engine light come on?

Check Engine Light comes on An illuminated Check Engine Light is another symptom of a bad or failing EGR control solenoid. If the computer detects an issue with the EGR solenoid, circuit, or system, it will set off the Check Engine Light to notify the driver of the issue.

What do you need to know about EGR codes?

A basic explanation of the valve works would probably help with the understanding of the diagnosis and repair of EGR codes. Exhaust gas recirculation is necessary for emissions purposes. Unfortunately, when it malfunctions it can actually push emission levels off the chart.

How can you tell if your EGR valve is faulty?

If your valve is working properly, you will observe a component inside the valve moving up and down. You can rev your engine a couple of times to be sure you are getting the movement. If you do not observe this movement, then it is a sign that your EGR valve is faulty.

What happens when you have a bad EGR valve?

This, in turn, reduces the car’s performance and increases pollution as well. When there is a problem with the EGR valve, the check engine light or EPC (VW) light may appear on your dashboard. The two main issues EGR valves face are that, either the valve stays open or it shuts completely.

What should I do if my EGR light is not working?

The repair of this condition is removal of the EGR valve and inspection of the passageway to check for a blockage. Each model vehicle has different procedures for clearing the passageway due to many different configurations of the system. Some Fords have a removable tube.

Where are the vacuum ports on an EGR solenoid?

The solenoid should click as it is powered by the battery. Remove one of the jumper wires from the battery and install vacuum hoses on the two vacuum ports located on the EGR solenoid. The solenoid controls a rapid-deployment valve to regulate the flow of vacuum, through the ports, to the EGR valve.

Why is there an EGR code on my Ford?

However, we often find EGR codes on Ford products caused by inexpensive plastic parts that falsely report position to the control module. Several technical service bulletins for a wide variety of different makes and models have documented different problems associated with the EGR valve system.

What does a check engine light mean on an EGR solenoid?