Most popular

What causes a 700R4 transmission to tip over?

What causes a 700R4 transmission to tip over?

Pete’s Transmission Threads janarvae’s 700R4 Transmission Rebuild The reason the transmission tipped over in the van was that the jack is a cheap Harbor Freight unit and the too-thin sheet metal bent from the tension on the trans holding strap and allowed the jack to come apart. This is the trans cradle (upside down).

How to install a TH-700R4 4L60 transmission?

Raise transmission and install crossmember as- sembly then tighten all bolts. Install three (M10 x 1.5 x 15) flexplate to converter bolts. Install the first bolt finger tight then use the starter motor to “bump” each drive lug into position. When all three bolts are installed torque them to 47Nm (35 ft.lbs.). STEP 8:(FIG.

What should I do for my first 700R4 rebuild?

If you’re diving into your first 700R4 rebuild (or maybe it’s just been a while), and are looking to verify some of the suggestions from your friends, local mechanics, or even the instructions from your rebuild kit, this is the write-up for you.

What kind of trans does a corvette 700R4 have?

Then I remembered that one of the guys in my Corvette club had taken the 700r4 out of his ’89 Corvette and replaced it with a ZF 6 speed manual trans. I figured he probably had the trans sitting in the corner of his garage gathering dust.

What’s the best way to install a 700R4 transmission?

How to Install a 700R4 Transmission. Step 1. Apply a high temperature grease to the main drive gear bearing retainer and the splined portion of the main drive gear. This will aid when Step 2. Step 3.

Is there a 700R4 conversion kit for early GM cars?

700R4 Conversion Kit for Early GM Cars and Trucks in 5 700R4 Levels and Price Points. Complete with everything but the driveshaft. You pick the power level for the transmission and the crossmember is determined by the vehicle type. We are PATC the company that developed Performance / Heavy Duty 700R4 transmissions since 1991.

Which is easier to install the 700R4 or the 4L60E?

Be forewarned, this can happen very quickly. Next, the 700R4 is easier to install since it does not require anything more than the TV cable hookup, shortening the driveshaft, moving the crossmember, and adding a 12-volt source to the transmission.

How big is the flywheel on a 700R4 transmission?

Install and torque the flywheel to converter bolts to 46 foot pounds. Install the transmission crossmember brace and torque both the crossmember and rear mount bolts to 35 foot pounds. Connect and adjust the shift linkage. There should be no slack in the linkage after adjustment.

Author Image
Ruth Doyle