What are the three main components of a disc brake system?

Disc brakes create braking power by forcing flat friction pads against the outer faces of a rotor. The vehicle’s kinetic energy is transformed into heat energy by the disc brake components, which slow the vehicle when applied. Disc brake assemblies consist of a caliper, brake pads, and a rotor.

What kind of tools do you need for differential gears?

Bearing pullers, dial indicators, brass punches, spanner wrenches…all of these specialty tools are required to swap ring and pinion gears and get them set up properly. There are also differential tools that make the job quicker and easier.

What are special tools are available for suspension repair?

If you’ve ever done this type of work or attempted to do it, you know it can be trickier than merely loosening and tightening bolts. For example, rubber bushings may need to be pressed out, ball joints may need to be pried out of spindles, and coil springs often need to be compressed for removal and installation.

What are special tools used in Brake Service?

Either way, a specially shaped brake bleeder wrench makes it easy to open and close bleeder valves on each caliper. Some examples we offer are the OEM Tools One Person Brake Bleeder Kit, CTA One Man Brake Bleeder Kit, and the Powerbuilt One-Man Brake Bleeder Master Kit just to name a few.

What kind of tool do I need to adjust brake shoes?

One hook grabs the spring as another arm of the tool wedges it off. Some import cars with smaller hold-down clips on the brake shoes may benefit from a compact, circular-ended brake clip tool . Adjusting clearance between brake shoes and drum with a starwheel adjuster tool.

What kind of tools do you need for rear end work?

Here are some great Differential tools that make the job go much easier. Rear end work can be difficult with out the right tools. Take the strain off yourself, your pullers, and your new bearings by purchasing these toolbox gems, avaialble for most models.

What kind of tool do you need to change brake pads?

A brake pad spreader or even a large c-clamp comes in handy when pressing the piston into the caliper. With this tool, you can easily retract the piston. This will allow you to reset the piston, and therefore, you will be able to fit the new brake pads. While there are different ways to push the piston, but using a C-clamp is much easier.