What are the gears inside a differential called?

In rear-wheel drive automobiles the central drive shaft (or prop shaft) engages the differential through a hypoid gear (ring and pinion). The ring gear is mounted on the carrier of the planetary chain that forms the differential. This hypoid gear is a bevel gear that changes the direction of the drive rotation.

What kind of axles does G2 axle and gear make?

When stock parts just won’t cut it, G2 Axle & Gear has what you need to make your 4×4 faster, stronger and more reliable. Best known for our huge selection of ring and pinions, G2 also produces axle shafts, locking differentials, hubs, housings and even complete axle assemblies.

What should I do to my front axle?

Refer to Lifting and Jacking the Vehicle in General Information. 2. Make sure the vehicle is level. 3. Inspect the front axle for leaks. Repair as necessary. 4. Clean the area around the front axle fill plug. 5. Remove the front axle fill plug (1). 6. Inspect the oil level.

How to disassembly and reassembly an IFS front axle?

Re: Complete disassembly and reassembly of a IFS front assembly. 1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information. 2. Make sure the vehicle is level. 3. Inspect the front axle for leaks. Repair as necessary. 4. Clean the area around the front axle fill plug. 5. Remove the front axle fill plug (1). 6.

What should the oil level be on a front axle?

If the level is low, add oil until the level is between 12-16 mm (0.50-0.625 in) for the 8.25 inch axle or 0-6 mm (0-0.25 in) for the 9.25 inch axle. Use the correct fluid. Refer to Sealers, Adhesives, and Lubricants .

What is the best gear ratio for towing?

A 3.73 ratio is suitable for regular light towing. If you plan on towing a fifth-wheel trailer or anything heavier than 5,000 pounds, you should consider a 4.1 axle ratio. A 4.1 ratio allows a towing vehicle to start moving without as much throttle.

What is your rear axle ratio?

How to Calculate the Rear Axle Gear Ratio Slide a floor jack under the rear of the vehicle and raise it until the rear wheels are off the ground. Crawl under the vehicle and locate the drive shaft where it attaches to the front of the rear axle. Place a piece of masking tape on the edge of one of the rear tires.

What is the gear ratio of a rear end?

Rear end gear ratios or final drive ratio refers to the number of revolutions the drive shaft turns compared to one full revolution of rear wheels. A 2.90 gear ratio means the drive shaft turns 2.9 times in one full turn of the rear wheels.

What are the gears inside a differential called?