Was there a runaway train in Stanton Pennsylvania?
Was there a runaway train in Stanton Pennsylvania?
Locomotive #8888, an EMD SD40-2, was pulling a train of 47 cars including some loaded with hazardous chemicals and ran uncontrolled for just under two hours at up to 51 miles per hour (82 km/h). It was finally halted by a railroad crew in a second locomotive, which caught the runaway and coupled to the rear car.
Is Unstoppable Based on a true story?
Unstoppable is a 2010 American action thriller film directed and produced by Tony Scott and starring Denzel Washington and Chris Pine. It is based on the real-life CSX 8888 incident, telling the story of a runaway freight train and the two men who attempt to stop it.
How did they stop the runaway train in Pennsylvania?
Daring maneuver. Alexander said CSX slowed the runaway by latching a second engine to the end of the train. The second engine applied its brakes, slowing the first enough for Hosfeld to make the climb just Southeast of Kenton, about 55 miles northwest of Columbus. ” That’s how the train slowed down,” Alexander said.
How realistic was unstoppable?
Answer: Yes, the 20th Century Fox film Unstoppable is inspired by actual events, but very loosely. In the film, the runaway train reaches speeds of 80 miles per hour and becomes a media sensation, though in real life the train was much slower and the actual incident was over before it became a major news story.
What was CSX 8888 carrying?
At lunchtime on May 15, 2001, CSX Locomotive No. 8888 eased down tracks in a rail yard outside Toledo, Ohio. The engine known as “Crazy Eights” picked up speed as it pulled 47 freight cars, two of them loaded with toxic chemicals, south toward Columbus. Only no one was on board.
What happened to Will Colson’s foot?
For reasons still unknown, he applied the throttle instead of a brake system. Panicked, the engineer tried to jump back on the train. But he lost his footing on rain-slicked steps and was dragged 80 feet before he let go.
Will Colson train conductor?
Will Colson is a young rookie train conductor who worked with Frank Barnes. Frank and Will catch up to 777 and attempt to engage the coupler. When the locking pin will not engage, Will kicks it into place, but gets injured in the process.
Who caused the CSX 8888 incident?
The incident began when an engineer climbed off the locomotive to adjust a switch, CSX officials said. The man, whose name was not released, set two of the train’s three braking systems correctly. But he mistakenly pulled the throttle lever instead of the one for the third, “dynamic” brake.
Where is the runaway train in unstoppable located?
The ceremony is held in a suburb in Stanton next to the train tracks where AWVR 777 and 767 and the rest of the runaway train is parked, for the press and the public to take pictures of it, admire it, and be able to look at it up close.
When did the runaway train happen in Walbridge Ohio?
It was just after noon on May 15, 2001 when eagle-eyed railway employees in Walbridge, Ohio noticed something peculiar about CSX 8888 — namely, that it seemed to be taking itself for a joyride.
What was the speed of the runaway train?
As the loose caboose passed Dunkirk, Ohio, a second engine was dispatched behind it and sent in pursuit with two engineers onboard. This part actually was pretty impressive — the rogue engine reportedly reached speeds upwards of 50 miles per hour during the final phase of its journey.
Who was the director of the runaway train?
The largely forgotten, critically beloved 2010 thriller, directed by Top Gun ‘s own Tony Scott, tells the story of a seemingly inauspicious locomotive with two special gifts: a “Little Engine That Could” attitude about chugging off unaccompanied at breakneck speeds, and a payload of highly toxic molten phenol.
