Is there a problem with the new window regulator?

The new regulator runs great up and down with out the window installed and the window will slide up and down no problem, the problem is when I combine the two. It runs very slowly and even stops sometimes about half way up. it sounds like its working really hard and binding up somewhere.

What to do about a power sliding rear window?

Refer to Rear Window Lower Garnish Molding Replacement (Ext Cab/Crew Cab w/A48) or Rear Window Lower Garnish Molding Replacement (Ext Cab/Crew Cab w/o A48) or Rear Window Lower Garnish Molding Replacement (Regular Cab) . NOTE: Use a suitable tool to lift upward on the rear sliding window stops (1) to remove. 3.

What’s the correct way to adjust driver’s side window?

The glass should contact the top of the window squarely and should seat against the window seal uniformly. NOTE: If the window does not contact the window seal uniformly, wind noise or water infiltration may result. Remove door panel as described in “411 Doors”.

How to install and remove a window regulator?

STEP 1: Secure gear plate to mounting bracket by drilling a hole through the center of the gear and gear plate and installing a bolt and nut to hold them together (Photo F) STEP 2: Remove screws, bolts or rivets and detach motor from bracket and gear. STEP 3: Check motor for obvious signs of wear. STEP 4: Reattach motor to regulator.

What is the regulator on a power window?

The window regulator is the actual frame of your power window in place while it is traveling up and down. If this is not working properly, then your window will not be moving. You can install this piece of your window fairly easily with some basic tools and a little bit of time.

Is there a problem with the new window regulator?