Is there a problem with my Ford F-350 automatic transmission?
Is there a problem with my Ford F-350 automatic transmission?
When attempting to shift between gears the vehicle would hesitate. The vehicle would also down shift into neutral gear while the rpms increased but the accelerator pedal did not respond. The failure occurred intermittently since the vehicle was purchased in August 2010. The dealer made two attempts to duplicate the failure.
Is there a problem with my Ford 350?
The contact owns a 2011 Ford F-350. When attempting to shift between gears the vehicle would hesitate. The vehicle would also down shift into neutral gear while the rpms increased but the accelerator pedal did not respond. The failure occurred intermittently since the vehicle was purchased in August 2010.
Why is my Ford F 350 not backing up?
The vehicle has never been used to pull trailers or heavy equipment so there is no reason for the transmission to be failing with so little mileage. The contact owns a 2005 Ford F-350 superduty. When the vehicle was placed into reverse, it would not back up.
Can a car stall when put in gear?
For the car, stalling is exactly the dead engine. No one wants to experience this frustrating feel. Basically, you can catch a car to stall when put in gear. Don’t worry if you have to face this issue because we have prepared the bottom information if your car engine gets stalled.
What kind of gears do I need for my Ford F 350?
The following gears, lockers and install kits are available for 2008 to 2010 Ford F-250 and F-350 Super Duty trucks with Dana 60 front axles and Ford Sterling 10.5″ rear axles. Note: Ford 10.25″ long pinion gears are also compatible with the Ford 10.5″ axle when a Ford 10.25″ master install kit is used.
Are there any problems with the automatic transmission on the Ford 350?
Ford F-350 owners have reported 64 problems related to automatic transmission (under the power train category). The most recently reported issues are listed below.
What kind of rear axle does a Ford F-350 have?
• F-350 models also used Dana 80 rear axles. • 1999-2007 Ford 10.5″ axle housings are identical to the earlier 1993-1998 Ford 10.25″ axles so both 10.25″ and 10.5″ gears will fit as long as the matching bearings are used. © Copyright Filthy Motorsports, DrivetrainShop.com – Do Not Copy or Reproduce Without Written Permission.
The vehicle has never been used to pull trailers or heavy equipment so there is no reason for the transmission to be failing with so little mileage. The contact owns a 2005 Ford F-350 superduty. When the vehicle was placed into reverse, it would not back up.
