Is there a problem with my 2004 Durango?

There was a problem with the early WCM or Keyless Entry Module. It won’t allow the programming of 2004 Durango: a problem with the early WCM or Keyless Entry Module… 2001 Dodge Durango Slt. Is it factory equipped with a key 2001 Dodge Durango Slt. Is it factory equipped with a key fob … read more

What kind of car is a Dodge Durango?

I have an 04 Dodge Durango built 10/03. I just had a remote start installed, they had to use spare key to program remote start (making key useless in ignition) I went to dealer today to get additional … read more

Is the Dodge Durango factory equipped with a key?

2001 Dodge Durango Slt. Is it factory equipped with a key 2001 Dodge Durango Slt. Is it factory equipped with a key fob … read more Little red circle light is flagging on my dashboard add car won’t start.

Is it possible to program a Dodge Durango key fob?

Most car makers allow you to program your car’s keyless remote by following a series of steps within the car. Dodge is no different; you can program your 2004 Durango key fob by simply getting into your vehicle and following a few simple steps.

Why do I need to reprogram my Dodge PCM?

– The original factory PCM programming might be overly sensitive or not take into account wear or other factors that may affect the operation of individual sensors or the OBD II monitors. – You need to resolve a hot or cold starting issue, idle roughness, stalling, or an emissions failure.

How do you reset the PCM on a Dodge Durango?

Another way to reset the PCM is to scan and clear any diagnostic trouble codes that have triggered the MIL light. You will need a scan tool or code reader/eraser to perform this; they’re not always readily available for everyone.

Where is the powertrain control module located on a Dodge Durango?

The powertrain control module (PCM) in your Dodge Durango is located on the right (passenger side) of the engine compartment.

How do you change the battery in a Durango?

Open the hood of the Durango. Locate the battery and remove the black-wired negative terminal from the battery. Turn the ignition key to the “on/crank” position for 30 seconds, then replace the ignition key to the “off” position. Reconnect the negative battery terminal and close the hood.

Do you need to replace the WCM in a JS?

Note: If the vehicle (a JS model vehicle in certain International markets) is equipped with an ELV, then the WCM and the ELV (P/N 05026132AC) must be replaced. Replace the WCM and then the ELV. Next program the WCM and at least one ignition key before programming the ELV.

When do you change the WCM on a Durango?

The PKU-CH2 supplies the vehicles with RFID and thus must be programmed if the Mfg date is after May 17th, otherwise the original WCM must be changed under warranty in order to program the PKU-CH2 to the Durango. The WCM replacement part number is XXXXX” I went though 3 different chip keys before coming across this.

Is there a warranty on a 2004 Durango?

Vocational, Technical or Tra… In reference to “A manufactureres issue exists with Durango vehicles built before May 17, 2004 and is covered under warranty. The WCM module … read more

Are there any recalls on Dodge Durango ignition keys?

The WCM module is defective and does not permit ANY additional RFID codes to be added to the vehicle. This includes new ignition keys (Sentry Keys). Instead of recalling all Durangos for this module swap, Chrysler is only changing the WCM when a Durango owner requests a new transponder key.

When to change transponder key on Dodge Durango?

Instead of recalling all Durangos for this module swap, Chrysler is only changing the WCM when a Durango owner requests a new transponder key. The WCM does not affect any other functions so is not a mandatory swap unless a new RFID is added.

Is there a remote start on a Dodge Durango?

The two keys are the ones that came with it. The mopar factory remote start comes with a device that fits around the ignition and “acts” like a key.

Is there a trick to resetting the 2004 Durango?

I ordered a mopar remote starter kit for my 2004 Durango complete with the new WCM module to let more than 2 sentry keys to be programmed. The problem is I can’t get the Durango to recognize the new WCM (won’t let my sentry keys start the vehicle)! Is there a trick to resetting the vehicle to accept the new WCM? anyone???

How many keys do you need to start a Durango?

The Durangos manufactured before 5/2004 are unable to detect any more than 2 sentry keys thus making the factory remote start inoperable (starts up and then dies after 2 seconds because it does not recognize a coded key in the ignition). So, they offer an updated wireless control module (WCM) that will accept up to 8 sentry keys.

Can You remote start a Dodge Grand Caravan?

Fully-integrated, OEM-tested, Remote Start system allows you to start your vehicle with just the push of a button. Imagine starting and warming your vehicle from your place of work or home on cold winter days, or cooling the same vehicle on hot summer days.