Most popular

Is the AC compresser on a Dodge Ram good?

Is the AC compresser on a Dodge Ram good?

Dodge Mechanic: sprinkles08, Chrysler/Dodge/Jeep master tech replied 8 years ago That’s good, you’ve ruled out the harness then. If you can’t actuate the compressor with a scan tool through the TIPM but the compressor and wiring are good then the TIPM is bad and will need to be replaced.

What is the problem with my Dodge compresser?

Dodge Mechanic: sprinkles08, Chrysler/Dodge/Jeep master tech replied 8 years ago If the compressor has been verified good then the problem has to be the TIPM or wiring between the TIPM and compressor. If there isn’t a code set for a circuit issue then the problem should be the TIPM.

Why is the AC not working on my Dodge Ram?

Air conditioning or heating systems on the Dodge Ram truck stop functioning from time to time. This all important system for… Dodge Ram AC or A/C not working. Air conditioning or heating systems on the Dodge Ram truck stop functioning from time to time. This all important system for…

Why does the a / C compressor clutch not come on?

The A/C compressor clutch doesn’t come on at all. Whether it be on MAX A/C or “medium” cool. This could be my schematic. Even if it is I don’t know what half of it means. Don’t worry about not knowing what it means, thats what we’re here for. That’s close, but it’s not the diagram we need. We need one for the whole a.c. system. Year make model?

Why is the compressor not working on my Dodge Ram?

If you end up with a full charge and the compressor still won’t work on it’s own, you have some other electrical problem that will require more diagnosis. But you first need to get enough of a charge that the AC system’s safety switches will allow the electrical part of the system to operate.

What causes an AC compressor to not engage?

If the clutch doesn’t engage, the problem could be a blown fuse, an open in the wire to the clutch coil, a bad clutch coil, a poor ground, or a low pressure lockout. AC compressor clutches receive power in a number of ways. They can activate through a relay that’s energized directly by a proper condition of the low and high pressure switches.

Why is the AC not working on my Dodge Dooley?

06 Dodge Dooley with Cummins. AC compressor will not engage. Ac wasn’t blowing cold. Replaced the fan clutch and ac went Ac wasn’t blowing cold. Replaced the fan clutch and ac went back to working.

What should the compressor pressure be in a Dodge Ram?

I hooked up the guages and while idling it shows about 35 PSI on low and about 180 PSI on hi side. According my repair manual the pressure should be 30-40 and 250. My reading is while idling and i think the correct chrysler reading should be at 2000 rpm which would be even lower and that would mean i’m low in refrigerant.

Why is my compresser not working on my Ram 3500?

If the compressor has been verified good then the problem has to be the TIPM or wiring between the TIPM and compressor. If there isn’t a code set for a circuit issue then the problem should be the TIPM. The first thing I would do is either disconnect the batteriesor reset the TIPM with your scan tool if it has that function.

Why is there no power to my AC compressor?

No 12 volts at comp plug. Went to heater control panel, have 12 V at ac switch, (with blower on) and so switch is sending it down the line but where it goes to, I don’t know. Can’t find any fuse or breaker labelled AC.

Is there a Dodge Ram with no power to AC?

I have a 2014 dodge ram with no power to AC clutch,system has full charge and replaced fuse box still I’m fellow tech. I have a 2014 dodge ram with no power to AC… Can you send me your vin number so I can pull up some wiring diagrams. Customer has vehicle so I don’t have vin at this time.

Is there no power to an A / C compressor?

No power to a/c compressor, I have checked the fuses, relays and freon. Clicking this will make more experts see the question and we will remind you when it gets answered. You can’t post conmments that contain an email address.

The A/C compressor clutch doesn’t come on at all. Whether it be on MAX A/C or “medium” cool. This could be my schematic. Even if it is I don’t know what half of it means. Don’t worry about not knowing what it means, thats what we’re here for. That’s close, but it’s not the diagram we need. We need one for the whole a.c. system. Year make model?

What to do if your Cummins compressor quits?

You’ll need an electrical schematic and a multimeter. And no, nothing in the system will keep it from kicking on if Its clogged, it would simply kick on and back off when it tripped the high pressure switch. Now, are you sure it only quits on max AC?

Author Image
Ruth Doyle