Is it illegal to make a left turn in Virginia?

No Left Turn: Left turns are against the law. In Virginia, U-turns are considered as two left turns and are illegal if this sign is posted. No Right Turn: Right turns are illegal. Do not make a right turn when you see this sign.

When to turn left on red at an intersection?

Look both ways and yield the right-of-way to pedestrians and other traffic. Be sure to check for less visible vehicles such as motorcycles, bicycles, and mopeds. You may not turn lefton red if signs are posted at the intersection that read “No Turn on Red,” or if a red arrow pointing to the left is displayed.

Can you make a left turn on a green light?

You may make a right, left turn, or U-turn on a green light, unless doing so is prohibited by a sign. However, you must yield the right of way to oncoming vehicles, bicycles, and pedestrians crossing the street who are close enough to pose a hazard.

What does it mean to yield at a stop sign?

Stop signs are sometimes accompanied by small, red multi-way supplemental plates (e.g., all-way and 4-way) that indicate whether other traffic also has a stop sign. A yield sign means that you must slow down, be ready to stop, and let other traffic (including pedestrians and bicycles) have the right of way before you continue driving.

What makes a car stall when making a left hand turn?

In this case, the owner of a 2002 GMC Envoy complained that his car would stall and die but only when making left hand turns. When checking out the vehicle the other symptom was a dim left headlight. Since the dim headlight situation isn’t dependent on vehicle movement, that’s the starting point.

Why does my voltage guage only show 9-10 volts?

My voltage guage usually points near the red mark at 9-10 volts. Batteries cranks the starter quickly and it does not seem to lack any electric power. Some times driving, it will raise to about 12 V, but never above, and the next minut point at 9 again.

What should the voltage be on a truck?

You want 12.4v -13v at the battery with 12.8v being ideal with the engine off. x3, load test the batteries one at a time first. Is the tach behaving nicely? or erratic?

What should I do if my car stalls when turning?

GM recommends installing a new stud and nut that’s properly treated for electrical conductivity and corrosion resistance. If you don’t want to do that, at least treat the clean surfaces with dielectric grease to slow due future corrosion. Alldatadiy.com and Eautorepair.net are professional-grade shop manuals—period.