How to wire a camper shell third brake light and interior?
How to wire a camper shell third brake light and interior?
For the interior lights, if they are on a switch, you can run a wire from 12 volt hot lead behind the factory 7-Way to the switch and then from the switch to the lights. You could also use the tail light circuit to power these lights if they are not switched. The running lights would have to be on for the lights to operate.
Where are the wires for the 3rd brake light?
My truck has a wiring set tied to the frame rail between the cab and bed of the truck on drivers side. It was tied to the frame there. Wires for an RV plug in the bed. In that pack of wires is wire number eight that if I recall is blue. It is for your third center brake light. Click to expand…
How do I wire my Truck Caps third brake Lite?
Run your wires down and connect the red to the light blue wire on the taillight. Connect the black wire with a self taping screw to the bed (right behind where the taillight sits. Take your white wire and run it to the positive side of the battery with a fuse inlined. Thats how mine was wired up and was installed by a LEER distributor
Where is the third brake light on a Silverado 1500?
This is the plug in the rear that has the circuit for the topper light and bed lighting. Did not splice into the third brake light. This is for my 2017 Silverado 1500, the harness number has changed but a couple more questions. 1.
For the interior lights, if they are on a switch, you can run a wire from 12 volt hot lead behind the factory 7-Way to the switch and then from the switch to the lights. You could also use the tail light circuit to power these lights if they are not switched. The running lights would have to be on for the lights to operate.
What kind of wire do I need for a 2008 GMC Sierra?
The chsm wire is your best bet on a 2008, that grommet will put you in the right spot to tap in. Would there also be a wire in the same bundle for a cargo light in the campershell.
This is the plug in the rear that has the circuit for the topper light and bed lighting. Did not splice into the third brake light. This is for my 2017 Silverado 1500, the harness number has changed but a couple more questions. 1.
How to wire a brake light on a truck?
Drill out the connector @ pin 1 to fit the pin in. Seal it up and plug back into the X6 connector. Zip tie your new wire up with the other harness and your install is complete. Enjoy your new working brake light. Without having to splice into the factory pigtail.
