How to replace the condenser on a Ford Focus?

FORD FOCUS AC CONDENSER REMOVAL REPLACEMENT. AC LEAK FIX – YouTube If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer. An error occurred while retrieving sharing information.

Why is the a / C not turning on on my Ford Fusion?

But on the Fusion, if the A/C compressor is not turning on, you will need to change the Evaporator Discharge Air Temperature Sensor. The sensor tells the computer what the air’s temperature is at the exit point of the evaporator. When it senses that it’s cold, it turns off the compressor.

How do you install a compressor on a Ford Fusion?

Remove the three instrument panel cowl side upper bolts. To install, tighten to 23 Nm (17 lb-ft). CAUTION: To avoid an improper connection at the bulkhead electrical connector, be sure to position the connector for installation then push the release handle to the full DOWNWARD position until it clicks.

Do you have to replace the condenser in your AC system?

Once they are bolted on and torqued to specifications you can move on to the next step. Inasmuch as you have opened the system to the atmosphere to replace the condenser, air containing moisture has been introduced. Therefore, the receiver/drier on your system MUST be replaced.

How do you remove an A / C compressor in a Ford Expedition?

Use a 1/2″ breaker bar inserted into the idler arm to push and release pressure on the belt so the belt can be removed from the compressor. One of the stages of the A/C compressor removal that most people don’t discuss is how to get it out after it is unbolted.

What’s the best way to remove an A / C compressor?

Some steps like removing the belt come first. Use a 1/2″ breaker bar inserted into the idler arm to push and release pressure on the belt so the belt can be removed from the compressor. One of the stages of the A/C compressor removal that most people don’t discuss is how to get it out after it is unbolted.

What should I do when my AC condenser is removed?

Before the AC condenser is removed from the vehicle the AC lines must be removed. Wear eye protection and preferably a face shield when removing refrigerant lines in case any residual pressure remains. Keep in mind the system contains (or contained) not just refrigerant but also refrigerant oil which could spatter in your face.

What kind of oil do I need to replace my AC condenser?

Consult the Factory Service Manual (FSM) and pour the required amount of new refrigerant oil (from a new sealed container so there is no moisture) into one of the refrigerant line ports of the condenser. Typically, about an ounce of oil is required but consult your FSM.

Do you have to replace the O-rings on an AC condenser?

The next step will be to replace the o-rings on the AC lines going to the condenser. Note: These o-rings can only be used one time and must be replaced or your system will leak. Coat the the o-rings with the system oil to ensure a good seal. Once the o-rings are replaced the lines can be bolted back to the condenser.

Where is the ignition coil on a Ford?

Locate the coil on your Ford engine. The coil looks like a black cylinder with a center wire similar to a spark plug wire and two side posts with nuts and wires attached. Remove the large wire from the center of the coil by pulling it straight out of the coil.

What should resistance reading be on Ford ignition coil?

Keep the other lead on the positive post of the coil. Note the resistance reading on the ohmmeter. Your coil should have a reading of between 6,000 and 15,000 ohms for your Ford. Replace the coil with a new one if the readings are outside either of these ranges, as that would indicate a defective coil.

When did the Ford Focus radiator come out?

The condenser stays in place with you remove the radiator. The model shown is a first generation 1998 to 2004, so covers years 1998, 1999, 2000, 2001, 2002, 2003, and 2004. Mark 1. Loading…

How many Ford Focus AC compressors are there?

Only 6 left in stock – order soon. . Only 5 left in stock – order soon. . . Only 5 left in stock – order soon. . . . Only 3 left in stock (more on the way). . Only 1 left in stock – order soon. . Only 17 left in stock – order soon. . Only 5 left in stock – order soon.

How to replace the condenser on a Ford Focus?