How to replace the blower motor on a Ford F-150?

How to replace the blower motor on a Ford F-150?

1 Remove the screws from the lower trim panel beneath the glove box 2 Remove the trim panel 3 Disconnect the wiring harnesses from the blower motor 4 Disconnect the blower motor sensor wiring harness 5 Remove the three 8mm bolts from the blower motor

What are the numbers on a Ford blower motor resistor?

As a cross reference: If your Ford vehicle uses one of the following blower motor resistor numbers, this tutorial applies to it: Airtex/Wells 4P1367. Dorman 973014 and 973015. Duralast JA1505.

Where is the blower motor resistor located on a Ford Escape?

In the 2008-2011 Ford Escape, the resistor is located behind the glove box on top of the HVAC unit air duct. It’s held by two screws and is easy to replace. See the photo. In the 2008-2011 Ford F150 the blower motor resistor is also located behind the glove box, but is installed in the right side of the plastic air duct.

How to test the Ford blower motor switch?

How To Test The Blower Motor Switch (Ford 4.6L, 5.4L). The Ford blower motor resistor assembly, covered by this tutorial, has 3 different resistors in series and depending through which resistors the blower motor current is flowing thru’ (on its way to ground) you’ll get one of three speeds: LO, M1, and M2.

How much does it cost to replace a fan resistor on a 1997 Ford F-150?

This feature is not available right now. Please try again later. If your 1997-2003 Ford F-150 A/C – heater fan only blows on high or doesn’t blow at the lower speeds, you most likely have a failed blower motor resistor. You could pay up to $400 to have a shop or the dealer replace it for you but you can do it yourself for as little as $20!

How to fix blower resistor on Ford F150?

FORD F150 BLOWER RESISTOR 1997-2003 FIX! Only blows on high – $20 (Short version) – MECHANICAL KID – YouTube FORD F150 BLOWER RESISTOR 1997-2003 FIX! Only blows on high – $20 (Short version) – MECHANICAL KID If playback doesn’t begin shortly, try restarting your device.

Why does my Ford F-150 blower only blow on high?

Please try again later. If your 1997-2003 Ford F-150 A/C – heater fan only blows on high or doesn’t blow at the lower speeds, you most likely have a failed blower motor resistor. You could pay up to $400 to have a shop or the dealer replace it for you but you can do it yourself for as little as $20!

What are the symptoms of a bad heater motor resistor?

Symptoms of a Bad or Failing Heater Blower Motor Resistor 1 Blower motor stuck on one speed A common symptom of a faulty blower motor resistor is a blower motor that is stuck on… 2 Blower motor does not work on certain settings Another common symptom of a faulty blower motor resistor is a a blower… 3 No air from the vehicle’s vents More