How to replace the antenna on a Chevy Silverado?

To avoid this, cancel and sign in to YouTube on your computer. An error occurred. Please try again later. (Playback ID: 5kvBUIFJXRbu-GIj) An error occurred while retrieving sharing information. Please try again later.

Where can I buy a GMC Sierra antenna?

Also sold under the GMC Sierra and VIA Vtrux names, available in the US, Canada, Mexico and other countries around the world. Antenna snapped off, unbolted antenna base from frame, how do I access antenna cable going to radio?

How do you replace a radio antenna in a car?

Apply the parking brake to prevent the vehicle from moving. Move the shift lever all the way down (if the transmission is automatic). Tilt the steering wheel to the full down position. Pull gently rearward on the retaining clips holding the bezel to the instrument panel (IP) assembly. Remove the bezel. Remove the end panels.

What’s the best way to replace an antenna?

Disconnect the antenna cable from the extension cable. Tie a long wire to the antenna cable. From outside of the vehicle, pull the antenna base and cable assembly until the wire can be easily accessible.

How to remove a radio antenna from a car?

Remove the assist handle by depressing the release tabs accessed through the air outlet duct holes. Remove the windshield pillar garnish (pillar) moldings. Disconnect the electrical connector (1) to the ambient light sensor on the underside of the trim pad. Remove the trim pad from the assembly. Remove the antenna mast.

How long does it take to replace an antenna on a GMC Acadia?

The antenna replacement steps covered in this “How To” tutorial will be the same or similar on many other vehicles such as a GMC Acadia, Subaru, Ford, Dodge, and many others. Replacing a broken roof-mounted antenna and base is an easy job that can be tackled in approximately half an hour.

What to do when you need to replace a radio antenna?

Radio Antenna Replacement. Set the air flow control to the instrument panel (IP) vent position if equipped with air conditioning (A/C). Disable the SIR system. Remove the SRS or AIRBAG fuse. Apply the parking brake to prevent the vehicle from moving. Move the shift lever all the way down (if the transmission is automatic).

Is there an easy antenna fix for a Chevy truck?

Easy Antenna Fix is a antenna repair kit for Chevy, GMC SUVs and Trucks and suvs from 1999-2018 that is simple. Easy Antenna Fix is simple solution to a potentially maddening situation where your trucks antenna was broke/sheared off where male screw stud from antenna base snaps off at car wash, vandalized or just by accident.

How big is antenna on 2014 Chevy Sierra?

2014 Sierra, first time trying to take off the antenna (after 7 years), and the stud completely broke off. i can only chock that up to GM putting gracious amounts of thread lock on it. I have about 1/8″ of stud left, about enough for one full turn of an antenna.

Where can I get parts for my Chevy Tahoe?

If you are the owner of this vehicle and looking for quality repair parts, then check out our website! CARiD.com offers a great variety of repair parts including brake parts, exhaust parts, engine parts, air intake parts, suspension parts, ignition parts, and tons of other products for a successful repair job!

When did the Chevy Tahoe go into production?

This model was introduced in 1992, and it is still in production. It is interesting to know that in February 2014, the Chevy Tahoe was the top-ranked Affordable Large SUV in U.S. News and World Report’s rankings.

How do you install a new antenna mast?

1.1) For installation of new antenna mast only, see steps 11 and 12. 1.2) Open glove box. 2.1) Pull right side of glove box toward center of glove box. This will allow glove box stop to pass dash and release toward floor. 3.1) Locate wire bundle in open on right side.

How do you remove an antenna from a car?

10.1) Remove trim panel over antenna mast. 11.1) With small wrench, loosen antenna mast. 12.1) Unscrew antenna mast to remove. 13.1) Use socket wrench to remove three mounting screws on antenna mast base. 14.1) Lift hood of vehicle and locate antenna bass and coax cable.

How to remove trim panel from antenna mast?

6.1) At antenna mast, pry edge of small trim panel surrounding antenna mast releasing clip. All clips release with pry pressure. 7.1) Continue prying across top of trim panel releasing clips. 8.1) Pry edge of trim panel releasing clip. 9.1) Lift trim panel from vehicle. 10.1) Remove trim panel over antenna mast.

How to replace the antenna on a Chevy Silverado?