How to replace power window motor on Dodge Ram?
How to replace power window motor on Dodge Ram?
Figure 1. Remove the T40 Torx screw. Pry the control panel off of the door and disconnect the two wire plugs. Figure 2. Disconnect the control panel plugs. Figure 3. Remove the door panel. Loosen the two 10mm bolt on the handle assembly. Remove the door lock rod from the handle assembly.
How much does it cost to replace the back window on a Dodge Ram?
The backlite/back window serves as part of the structural support for the roof and is bonded with urethane that is hard to cut or clean off of any surface. Purchasing a new backlite will set you back over $400, so take this into consideration beforehand.
What is the regulator on a Dodge Ram?
This article applies to the Dodge Ram (2002-2008). The window motor on your Dodge Ram is part of a bigger component called a regulator. A regulator is comprised of two rails that push the window up, or pull it down, by use of the window motor.
How do you replace a window regulator on a car?
Play with the controls until you align the window bracket bolts behind the access ports. Loosen the two 10mm bolts and pull the window up by hand. Use several straps of painter’s tape to hold the window in place, while the regulator is replaced (refer to Figure 7). Figure 6. Align the window and remove the 10mm bracket bolt.
How do you replace a window motor on a blazer?
Unplug the window motor wiring connector by hand. Remove the broken motor from the Blazer’s door. Place the Blazer’s new window motor in the door by hand. Bolt it in place using a socket set. Plug the wiring connector into the new motor manually. Reinstall the Blazer’s door panel by reversing the method used to remove it.
How do you remove a power window motor?
Remove the motor and regulator through the access port. With the pigtail disconnected, the power window motor and regulator will no longer be connected to anything inside the door. Reach into the large access port and pull them each out. The two are connected, so pulling one will remove them both.
How do you replace a power window regulator?
Replace the mounting bolts. Hold each component in the appropriate position as you return the mounting bolts that secure both the power window motor and the regulator. Thread each bolt in by hand first, then use a wrench to tighten them. If a bolt doesn’t thread it properly, remove it and try again to prevent cross-threading them.
How do you disconnect a power window motor?
The power window controls attach to the motor and regulator via a wiring pigtail connector. Press the tab down to disconnect the pigtail then pull them apart to disconnect the motor. Be careful not to break the tab that holds the wiring harness together.
Replace the mounting bolts. Hold each component in the appropriate position as you return the mounting bolts that secure both the power window motor and the regulator. Thread each bolt in by hand first, then use a wrench to tighten them. If a bolt doesn’t thread it properly, remove it and try again to prevent cross-threading them.
Is it time to replace power window motor?
If you have identified the motor as the culprit, replacing it is fairly straight forward, though it can be time consuming. It is recommended that you review a service manual specific to your vehicle when replacing the motor, as the methods used to disassemble car doors can vary from vehicle to vehicle.
What’s the best way to replace a power window?
Raise the window up into the door frame. Have your friend raise the window up into the door frame as though you had rolled it up normally. Ask them to hold the window in place until you are able to secure it. Pressing one palm on each side of the glass will allow your friend to hold the window up. Use masking tape to secure the window in place.
