How to repair and replace TPS on Dodge Ram?

The following instructions explain how to complete both the full TPS replacement and its repair. Use a Torx driver to remove the mounting screws. Disconnect the sensor from the harness plug. Figure 1. Disconnect the harness plug and remove the Torx screws.

How do you change the TPS on a Honda Accord?

Position the new TPS on the throttle body. Orient the new TPS exactly as the previous one. Put the fasteners in place and torque them to 50 inch pounds. Check the throttle for binding by opening it to “wide open” and then closing it several times to assure proper operation. Plug in the throttle position sensor connector.

How do you remove a throttle position sensor?

Part 1 of 2: Removing the throttle position sensor. Step 1: Locate the sensor. The throttle position sensor is mounted to the throttle body on top of the engine. Step 2: Disconnect the negative battery cable. Disconnect the negative battery cable and set it aside. Step 3: Remove the sensor electrical connector.

How do you repair a TPS air conditioner?

Use a Torx driver to remove the mounting screws. Disconnect the sensor from the harness plug. Figure 1. Disconnect the harness plug and remove the Torx screws. If you are on a tight budget, you can try using this temporary repair procedure that allows the TPS to read the airflow better.

When to replace the TPS sensor on a Dodge Magnum?

If your truck experiences poor idle, terrible acceleration or worse gas mileage, then its time to replace that TPS sensor. For Dodge ‘Magnum’ engines 239 (3.9L) V6, 318 (5.2L) and 360 (5.9L) V8 from 1993 to 2003. Keep in mind that there are minor differences in the electrical connections, but the removal is the same. Loading…

What causes a bad Throttle Position Sensor ( TPS )?

A bad or worn throttle position sensor (TPS) will make your truck act all kinds of crazy. From surging and erratic idles to poor fuel consumption. Diagnosing the TPS is also finicky, as the many of its symptoms are relative to most of the vacuum and idle controls found on the vehicle.

What should I do if my TPS is failing?

There are two common ways to approach a failing TPS: one is to replace the unit in its entirety, while the other is more of a quick patch that will eventually have you replacing the unit regardless. However, the temporary repair is a viable option when the budget is important.

How to repair and replace TPS on Dodge Ram?