How to install a HEI distributor on a car?
How to install a HEI distributor on a car?
HEI Distributor Installation Instructions. DISTRIBUTOR REMOVAL. 1. Disconnect the negative battery cable. 2. Disconnect the vehicle wiring harness, and distributor wiring harness from the distributor cap. 3. Remove the distributor cap, leaving the spark plug wires attached. Set the cap and wires out of the way.
Where do the resistance wires start on a HEI distributor?
Most resistance wires begin at the engine compartment side of the fuse block. If a ballast resistor is present: remove the wires attached to both sides of the resistor. Connect all of the wires removed together at a single point. Isolate the connection from any grounds.
What kind of wrench do I need for a Hei conversion?
A special 9/16″ offset wrench is available for this if you have a hard time reaching the bolt with a regular wrench. With the bolt loose, slide the hold-down tab back away from the distributor and pull the distributor straight up out of the engine.
Can a GM points distributor be swapped to Hei?
With the exception of firewall clearance problems in various vehicles, this should apply to swapping most any GM points type distributor to HEI. Some benefits from the HEI swap include reduced maintenance, easier starting, and often a small improvement in gas mileage. Finding an HEI Distributor There are a couple of choices here, new or used.
Where is the ignition coil on a HEI distributor?
The HEI distributor actually houses the ignition coil underneath that massive cap. You will need to purchase a new set to match your new distributor. With that said, reattach your individual plug wires to their proper posts. Take your time and make sure you have them right.
Where is the HEI distributor on the cap?
Now install the distributor with the rotor pointing at the No. 1 terminal on the cap. When reconnecting the new unit, you will need to purchase and splice in a single HEI terminal connector.
How do you remove a HEI distributor from a Chevy?
Soak with penetrating oil and work carefully to avoid damaging the bushings. With the shaft out, the pick-up coil and pole piece assembly can be removed by carefully removing the snap ring from the upper end of the bushing. Once the distributor is fully dis-assembled, thoroughly clean everything.
Can you hook up a HEI to a hot ignition lead?
With the ignition coil neatly tucked inside the HEI, it makes the electrical hook-up a cinch. All you need to do here is splice the HEI connector into your existing “hot” ignition lead.
