How many hours does a Deere 323d tracked skid steer have?

It has 823 hours on it. Any time of the day, if it hasn’t been running for a while, 8 hours or so, It has a hard time starting. It cranks over just fine. Cranks really fast and you can tell it’s trying to start. It blows a little black smoke while cranking then after 20 -30 seconds it will start.

How to clear codes on a John Deere skid steer?

Mike Gamby, service supervisor at Papé Machinery Construction & Forestry in Eugene, Oregon details the steps for how to clear the codes on a John Deere skid steer below. This walkthrough is specific to the John Deere 320E.

What’s the fuel pressure on a Deere 323d?

As soon as I cranked it the fuel pressure went to 30 psi almost immediately but it had the same hard start condition. When I shut it down, the fuel pressure slowly dropped to 0. It took about 3-5 minutes. I had the fuel return line disconnected during this time and no fuel came out of it while the pressure was dropping.

What is the ECU on a Deere 323d?

ECU 000651.05 These are all engine fuel injection system codes. Hydraulic oil filter is restricted. I believe most of these codes are from when I was testing the glow plug circuit. I had a lot of the wires disconnected and was turning the key on and off to get voltage readings.

How many hours does a John Deere 323d have?

It’s a 2013 that’s sitting in a non JD dealer on consignment has about 600 hours on it, tracks are about 30% ($$$$$) and it’s 36K $can. Still back and forth between wheel machine/aftermarket tracks and a CTL.

Is the quick attach on a John Deere skid hydraulic?

They put about 400 hours on it and the door and loose hydro were the only issues we had. Quick attach is not hydraulic, it’s a electric linear actuator (IIRC). Similar to a gator dump bed lift. Not as strong as hydraulic. Keep it greased on it will give you trouble. Another guy near me rents all Deere skids.

How many hours does a Deere 323d tracked skid steer have?