How do you turn off ABS on a Delco?

Pull the solenoid connectors off the master cylinder and push the resistor modules into them. Make sure you’ve put the solenoid fuses back in. The ABS lamp will now turn off.

Is there a way to disable the ABS solenoids?

Several tests were done to improve the brake feel and the solution I found was to disable the ABS solenoids. There are three solenoids – two for the front brakes and one solenoid supplies both the rear. What is achieved by disabling the solenoids, is that the back pressure is removed and you achieve a ‘realistic’ feel to the brakes again.

Where is the relay for the ABS system?

Most ABS systems typically have individual sensors mounted on or near each wheel. However, they are all controlled by a central relay that is located in the main relay panel inside your engine compartment. If you ever have to disable your ABS system, the relay is the most direct and effective way to handle it.

Is there a way to disable the ABS system?

However, they are all controlled by a central relay that is located in the main relay panel inside your engine compartment. If you ever have to disable your ABS system, the relay is the most direct and effective way to handle it. Pop your hood and remove your negative battery cable. Locate your main relay box.

How can I reset the GM ABS brake module?

Navigate to the “ABS” menu on the computerized scan tool by pushing the down arrow button. Select “Clear all codes.” Power off the computerized scan tool and disconnect it from the DLC connector. Turn on the vehicle and verify that the ABS module is no longer lit. A computerized scan tool can be purchased online, or at any automotive supply store.

Why does my GM ABS brake still run?

The antilock brake system (ABS) is controlled by its own computer. When it senses a problem, the ABS module on the dashboard will light up. When the problem is fixed, the module will sometimes still stay on, and it will need to be rest.