How do you turn a skid steer on?
How do you turn a skid steer on?
Pull the single arm control towards you to go backwards. Move the single arm control left or right to turn the skid steer left or right. Go up the steps while holding the grab handles with both hands. Step into the cab and turn around as you enter. Adjust the seat and other amenities to your liking.
What to do if your skidsteer wont start?
The engine will not crank when the key start switch is in the START position. Test Step 1. CHECK ARMREST INDICATOR Occupy the seat. Lower the armrest. Turn the key start switch to the ON position. Check the status of the armrest indicator and the parking brake indicator.
How to check the skid steer loader battery?
CHECK THE VOLTAGE AT THE STARTING MOTOR Locate wire 304-WH on the starting motor. Turn the key start switch to the START position. Note: Two people will need to perform this procedure. One person will need to sit in the seat with the armrest down holding the key start switch to the START position.
How to get a cat 246 skidsteer to start?
CHECK THE INPUT TO THE INTERLOCK ECM Turn the key start switch to the OFF position. Locate the interlock ECM. Remove the harness from the interlock ECM. Jumper contact 64 to contact 62 of the wire harness connector. Turn the key start switch to the START position. The engine should crank. OK – The engine cranks.
The engine will not crank when the key start switch is in the START position. Test Step 1. CHECK ARMREST INDICATOR Occupy the seat. Lower the armrest. Turn the key start switch to the ON position. Check the status of the armrest indicator and the parking brake indicator.
CHECK THE VOLTAGE AT THE STARTING MOTOR Locate wire 304-WH on the starting motor. Turn the key start switch to the START position. Note: Two people will need to perform this procedure. One person will need to sit in the seat with the armrest down holding the key start switch to the START position.
CHECK THE INPUT TO THE INTERLOCK ECM Turn the key start switch to the OFF position. Locate the interlock ECM. Remove the harness from the interlock ECM. Jumper contact 64 to contact 62 of the wire harness connector. Turn the key start switch to the START position. The engine should crank. OK – The engine cranks.
What should the voltage be on a skidsteer?
One person will need to sit in the seat with the armrest down holding the key start switch in the START position. Measure the voltage at wire 304-WH on the start relay. The voltage should be equal to or greater than 10 DCV. OK – The voltage is equal to or greater than 10 DCV.
