How do you tell if my Cj7 is a Laredo?
How do you tell if my Cj7 is a Laredo?
One sure way to tell if it was a Laredo at conception is to look at the trim code on the VIN tag. You should have some letters like 5EB or something. If yours was a black Laredo at conception, your three digit trim code would be 1EJ.
Will Cj5 fenders fit a Cj7?
Yes, you can just cut the older ones, but then there are differences in the shape of the inner fenders for the different components like water bottles, support rods, relays, moduals, etc.
Are CJ and YJ fenders the same?
The YJ front fenders are longer than a CJ’s plus the profile of the flare at the back has more of an angle to it than the CJ opening. At the rear the YJ flare is the same as a CJ flare (no tub trimming) but gives you a tad more coverage.
Are cj5 and cj7 hoods the same?
Theres no difference between the hood on a CJ-7 and on a CJ-5. The difference is made up in the length of the body tub, not in the engine bay. So yes the CJ-7 hood would bolt up but it wouldn’t stretch your engine bay any. 78 CJ-5 (now a CJ-7), 351W, T-18, SOA, etc.
Will YJ fender flares fit a CJ?
The CJ rear fender flares look good with stock size tires, but look alittle goofy with oversized tires. I decided to try on some YJ rear fender flares to see if they fit, and it turns out that they do. YJ rear fender flares will bolt directly onto a CJ.
Are all CJ hoods the same?
No, they are not all the same. The CJ 5 hoods were shorter until ’71. In ’72 and after all the CJ hoods are the same general shape and the same size.
Where are the repair clips on a Jeep CJ7?
Jeep Foot Area Repair Clips. Outside edge is rolled down as was original. None of our panels are cosmetically coated. Click here to find out why. Our rear of front floor repair panel is for the area that rusts out under the roll bar mount and seat belt area. The outside edge is rolled down as was original.
Where are the body mounts on a Jeep CJ7?
Includes all major factory mounting locations, including channels for body mounting. Dashes and shifter tunnels left blank in some applications with varied OE locations.
How are tailgates attached to a Jeep CJ7?
All tailgate end supports are intended to attach the body to the frame via a body bolt at each end of the support. All captured nuts brought to original factory size and standard. We have paid very close attention to quality and detail and thus have an exceptional product for you.
What are the part numbers for CJ5 and CJ7?
FOR PART NUMBER’S: 1520800010, 1520800020, 1520800051, 1526800010, 1526800020, 1526800051 Instruction # 8000000010 REV 09/15
