How do you reset the service light on a Eaton transmission?
How do you reset the service light on a Eaton transmission?
Turn the key off and on 4 times within five seconds ending with the key in the on position. After 5 seconds, the Service light begins flashing two-digit fault codes. If no faults are active, the service light will flash code 25 (no codes). Two digit fault codes will be displayed in the gear display.
Does Eaton Fuller make a automatic transmission?
The AutoShift™ is a partially automated Eaton® Fuller® transmission that automatically selects and engages the transmission’s gears. The driver must use the clutch to start and stop the vehicle. A shift begins when the Auto- Shift™ computer detects that conditions are right for a shift.
Why does my Eaton Fuller not shift gears?
My eaton fuller autoshift suddenly will not go into any gears in my driveway, just shows down arrows and R or 2 (flashing) when I try to go into any gear. When i have the truck off and turn key to start position and try to shift gears i can hear the transmission shifting successfully, however once the engine is running it will not shift gears.
Is there charge for Eaton Fuller Autoshift service?
There is no charge for this service, but standard message and data rates may apply. My eaton fuller autoshift suddenly will not go into any gears in my driveway, just shows down arrows and R or 2 (flashing) when I try to go into any gear.
How to retrieve Eaton Fuller transmission fault codes?
Place the shift lever in neutral. Set the parking brake. Turn key on with engine off. Note: If the engine is already running, you may still retrieve codes; however, do not engage the starter if the engine stalls. To Retrieve Active Codes: Key on. Turn key off and on 2 times within five seconds ending with the key on.
What kind of transmission does a Freightliner have?
I have an Eaton 10-speed autoshift transmission and a Detroit engine in my 2001 Freightliner. I am having problems with the transmission. Some times it will not downshift below the 6th gear. It happened 4 times when I was driving a 160 miles trip.
What to look for in an Eaton Fuller automatic transmission?
Check the wiring between the Transmis- sion ECU and the Push Button Shift Control. Gear Display Lamp check: This is OK. Dash on the Gear Display: Transmission ECU and the Push Button Shift control are communicat- ing. The transmission is trying to verify Neutral and it can’t. It may be torque locked in gear. Or bad Powers and Grounds.
My eaton fuller autoshift suddenly will not go into any gears in my driveway, just shows down arrows and R or 2 (flashing) when I try to go into any gear. When i have the truck off and turn key to start position and try to shift gears i can hear the transmission shifting successfully, however once the engine is running it will not shift gears.
How to troubleshoot an Eaton ultrashift plus fault code?
When troubleshooting an Inactive fault code, use the Fault Isolation Procedures to guide you to the wiring and connectors associated wi th that fault. Once PD Mode is activated, flex the wiring harness and connectors to attempt to recreate the fault.
Why do you need A Fuller transmission book?
This book contains information needed to cross reference most Fuller transmission models produced between 1985 and current production. It allows you to order and/or stock a Reman, New, or New Exchange Unit to meet customer requirements.
